Next Article in Journal
Structural and Magnetoresistance Properties of Transfer-Free Amorphous Carbon Thin Films
Previous Article in Journal
Application of Dimming Compensation Technology Via Liquid Crystal Lens for Non-Imaging Projection Laser Systems
Article Menu
Issue 3 (March) cover image

Export Article

Open AccessArticle
Crystals 2019, 9(3), 123; https://doi.org/10.3390/cryst9030123

Surface Integrities of Different Trajectories in Belt Grinding for Pure Iron Functional Performance Test Pieces

The State Key Laboratory of Mechanical Transmissions, Chongqing University, No. 174, Shazhengjie, Shapingba, Chongqing 400044, China
*
Author to whom correspondence should be addressed.
Received: 21 January 2019 / Revised: 19 February 2019 / Accepted: 22 February 2019 / Published: 27 February 2019
  |  
PDF [7429 KB, uploaded 4 March 2019]
  |  

Abstract

In order to reduce the influence of surface burns and other defects in the processing of pure iron parts for a functional properties test, and to improve the accuracy and usability of the test results, abrasive belt grinding is used for surface grinding. Because of the long circumference of the belt, and the long cooling time of the abrasive particles, cold grinding can be achieved, so that the incidence of surface burns, machining hardening, and other defects can be reduced. An experimental platform for belt grinding of pure iron parts for a functional properties test was built, and corresponding belt grinding experiments were carried out. The influences of grinding parameters, such as belt velocity, feed velocity, the grinding track on the microcosmic morphology, surface roughness, surface residual stress, and micro-hardness were studied. The results showed that belt grinding improved the surface integrity, the surface roughness was less than Ra 0.4 μm, the surface residual stress ranged from −253.84 MPa to −164.14 MPa, and the micro-hardness ranged from 118 HV to 170 HV. Furthermore, to get the workpiece surface to mostly suit the functional performance test, a high abrasive belt linear speed, a low grinding depth, and a feed speed should be selected, and the processing should be conducted with a circular trajectory. View Full-Text
Keywords: industry pure iron; belt grinding; trajectory planning; surface integrity industry pure iron; belt grinding; trajectory planning; surface integrity
Figures

Figure 1

This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited (CC BY 4.0).
SciFeed

Share & Cite This Article

MDPI and ACS Style

Liu, Y.; Dai, W.; Xiao, G.; Huang, Y. Surface Integrities of Different Trajectories in Belt Grinding for Pure Iron Functional Performance Test Pieces. Crystals 2019, 9, 123.

Show more citation formats Show less citations formats

Note that from the first issue of 2016, MDPI journals use article numbers instead of page numbers. See further details here.

Related Articles

Article Metrics

Article Access Statistics

1

Comments

[Return to top]
Crystals EISSN 2073-4352 Published by MDPI AG, Basel, Switzerland RSS E-Mail Table of Contents Alert
Back to Top