Next Article in Journal
Assessment of Aging Impact on Wax Crystallization in Selected Asphalt Binders
Previous Article in Journal
Hot Deformation Behavior and Simulation of Hot-Rolled Damage Process for Fine-Grained Pure Tungsten at Elevated Temperatures
 
 
Article
Peer-Review Record

Performance Test and Thermal Insulation Effect Analysis of Basalt-Fiber Concrete

Materials 2022, 15(22), 8236; https://doi.org/10.3390/ma15228236
by Xiao Zhang 1,2, Shuo Zhang 1,2 and Song Xin 1,2,3,*
Reviewer 1: Anonymous
Reviewer 2:
Materials 2022, 15(22), 8236; https://doi.org/10.3390/ma15228236
Submission received: 10 October 2022 / Revised: 25 October 2022 / Accepted: 26 October 2022 / Published: 21 November 2022
(This article belongs to the Section Advanced Composites)

Round 1

Reviewer 1 Report

 

The authors had made a significant contribution by studying s the feasibility of applying inorganic thermal insulating concrete in high-ground temperature roadways in underground coal mines. Following are my suggestions.

1. Please modify the title and make it more specific.

2. Add more relevant keywords.

3. Please improve the introduction. Add more about benefits of basalt fibers and types of FEM in the introduction. Please refer to https://doi.org/10.1016/j.jobe.2020.101689 ;https://doi.org/10.1002/fam.2968 ; https://doi.org/10.1016/j.conbuildmat.2022.126340

4. Please write clearly the objective and significance of your work in the last paragraph of introduction.

5. Please improve the Figure 2 and 3 quality.

6. A comparison with previous study is necessary.

7. Add a discussion section before conclusion regarding practical implementation of current study.

8. Please make bullet point in conclusion.

9. What are your future recommendation.

10. Moderate English changes required.

11. References are too old. Please update.

12. Overall the study is good and results are impressive.

 

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Reviewer 2 Report

1- The Abstract is 394 words; I suggest the authors reduce it to approximately 250-270 words.

2- The authors should present a table for all information between lines 134-141.

3- The authors should use a bigger size for figure 3; the information and images are not clear.

4- I suggest, For input parameters (mixed design), the authors use a correlation matrix graph.

5- The authors should compare their results with standard codes and other researchers. It is essential for the validation of their results.

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Round 2

Reviewer 2 Report

The paper improved, and the authors responded to all comments.

Back to TopTop