Next Article in Journal
Investigation on Optimization Design of Offshore Wind Turbine Blades based on Particle Swarm Optimization
Next Article in Special Issue
Real-Time Reliability Monitoring of DC-Link Capacitors in Back-to-Back Converters
Previous Article in Journal
Experimental and Numerical Characterization of the Sliding Rotary Vane Expander Intake Pressure in Order to Develop a Novel Control-Diagnostic Procedure
Previous Article in Special Issue
Elimination of Common Mode Voltage in Three-To-Six-Phase Matrix Converter
 
 
Font Type:
Arial Georgia Verdana
Font Size:
Aa Aa Aa
Line Spacing:
Column Width:
Background:
Article

A Generic Control-Oriented Model Order Reduction Approach for High Step-Up DC/DC Converters Based on Voltage Multiplier

1
College of Electrical Engineering & New Energy, China Three Gorges University, Yichang 443002, Hubei, China
2
School of Electrical Engineering and Computer Science, Queensland University of Technology, Brisbane, QLD 4001, Australia
3
School of Automation, Wuhan University of Technology, Wuhan 430070, Hubei, China
*
Author to whom correspondence should be addressed.
Energies 2019, 12(10), 1971; https://doi.org/10.3390/en12101971
Submission received: 10 April 2019 / Revised: 15 May 2019 / Accepted: 20 May 2019 / Published: 23 May 2019
(This article belongs to the Special Issue Control in Power Electronics)

Abstract

The modeling and control system design of high step-up DC/DC converters based on voltage multipliers (VMs) are difficult, due to the various circuit topologies and the presence of large number of capacitors in VMs. This paper proposes a generic approach to reduce the model order of such converters by replacing the VM capacitors with voltage sources controlled by the output voltage of the converter. Theoretical analysis and simulation results show that the derived models can accurately represent the low frequency response of the converter which is valuable for obtaining a small-signal AC model for control system design. The detailed modeling and controller design process are demonstrated for the converter, and the obtained simulation results are verified experimentally on a 400 W prototype.
Keywords: DC/DC converter; reduced order model; high step-up converter; voltage multiplier (VM); control system design DC/DC converter; reduced order model; high step-up converter; voltage multiplier (VM); control system design

Share and Cite

MDPI and ACS Style

Zhu, B.; Zeng, Q.; Vilathgamuwa, M.; Li, Y.; Chen, Y. A Generic Control-Oriented Model Order Reduction Approach for High Step-Up DC/DC Converters Based on Voltage Multiplier. Energies 2019, 12, 1971. https://doi.org/10.3390/en12101971

AMA Style

Zhu B, Zeng Q, Vilathgamuwa M, Li Y, Chen Y. A Generic Control-Oriented Model Order Reduction Approach for High Step-Up DC/DC Converters Based on Voltage Multiplier. Energies. 2019; 12(10):1971. https://doi.org/10.3390/en12101971

Chicago/Turabian Style

Zhu, Binxin, Qingdian Zeng, Mahinda Vilathgamuwa, Yang Li, and Yao Chen. 2019. "A Generic Control-Oriented Model Order Reduction Approach for High Step-Up DC/DC Converters Based on Voltage Multiplier" Energies 12, no. 10: 1971. https://doi.org/10.3390/en12101971

APA Style

Zhu, B., Zeng, Q., Vilathgamuwa, M., Li, Y., & Chen, Y. (2019). A Generic Control-Oriented Model Order Reduction Approach for High Step-Up DC/DC Converters Based on Voltage Multiplier. Energies, 12(10), 1971. https://doi.org/10.3390/en12101971

Note that from the first issue of 2016, this journal uses article numbers instead of page numbers. See further details here.

Article Metrics

Back to TopTop