Next Article in Journal
Dynamic Navigation and Area Assignment of Multiple USVs Based on Multi-Agent Deep Reinforcement Learning
Next Article in Special Issue
Towards Interpretable Camera and LiDAR Data Fusion for Autonomous Ground Vehicles Localisation
Previous Article in Journal
Short-Term HRV Detection and Human Fatigue State Analysis Based on Optical Fiber Sensing Technology
Previous Article in Special Issue
Adaptive Data Fusion Method of Multisensors Based on LSTM-GWFA Hybrid Model for Tracking Dynamic Targets
 
 
Font Type:
Arial Georgia Verdana
Font Size:
Aa Aa Aa
Line Spacing:
Column Width:
Background:
Article

Expectation–Maximization-Based Simultaneous Localization and Mapping for Millimeter-Wave Communication Systems

Shaanxi Key Laboratory of Deep Space Exploration Intelligent Technology, School of Information and Communications Engineering, Xi’an Jiaotong University, No. 28 West Xianning Road, Xi’an 710049, China
*
Author to whom correspondence should be addressed.
Sensors 2022, 22(18), 6941; https://doi.org/10.3390/s22186941
Submission received: 4 August 2022 / Revised: 2 September 2022 / Accepted: 5 September 2022 / Published: 14 September 2022

Abstract

In this paper, we proposed a novel expectation–maximization-based simultaneous localization and mapping (SLAM) algorithm for millimeter-wave (mmW) communication systems. By fully exploiting the geometric relationship among the access point (AP) positions, the angle difference of arrival (ADOA) from the APs and the mobile terminal (MT) position, and regarding the MT positions as the latent variable of the AP positions, the proposed algorithm first reformulates the SLAM problem as the maximum likelihood joint estimation over both the AP positions and the MT positions in a latent variable model. Then, it employs a feasible stochastic approximation expectation–maximization (EM) method to estimate the AP positions. Specifically, the stochastic Monte Carlo approximation is employed to obtain the intractable expectation of the MT positions’ posterior probability in the E-step, and the gradient descent-based optimization is used as a viable substitute for estimating the high-dimensional AP positions in the M-step. Further, it estimates the MT positions and constructs the indoor map based on the estimated AP topology. Due to the efficient processing capability of the stochastic approximation EM method and taking full advantage of the abundant spatial information in the crowd-sourcing ADOA data, the proposed method can achieve a better positioning and mapping performance than the existing geometry-based mmW SLAM method, which usually has to compromise between the computation complexity and the estimation performance. The simulation results confirm the effectiveness of the proposed algorithm.
Keywords: simultaneous localization and mapping (SLAM); expectation–maximization (EM); millimeter-wave communication systems; angle difference of arrival (ADOA); the stochastic Monte Carlo approximation simultaneous localization and mapping (SLAM); expectation–maximization (EM); millimeter-wave communication systems; angle difference of arrival (ADOA); the stochastic Monte Carlo approximation

Share and Cite

MDPI and ACS Style

Chen, L.; Chen, Z.; Ji, Z. Expectation–Maximization-Based Simultaneous Localization and Mapping for Millimeter-Wave Communication Systems. Sensors 2022, 22, 6941. https://doi.org/10.3390/s22186941

AMA Style

Chen L, Chen Z, Ji Z. Expectation–Maximization-Based Simultaneous Localization and Mapping for Millimeter-Wave Communication Systems. Sensors. 2022; 22(18):6941. https://doi.org/10.3390/s22186941

Chicago/Turabian Style

Chen, Lu, Zhigang Chen, and Zhi Ji. 2022. "Expectation–Maximization-Based Simultaneous Localization and Mapping for Millimeter-Wave Communication Systems" Sensors 22, no. 18: 6941. https://doi.org/10.3390/s22186941

APA Style

Chen, L., Chen, Z., & Ji, Z. (2022). Expectation–Maximization-Based Simultaneous Localization and Mapping for Millimeter-Wave Communication Systems. Sensors, 22(18), 6941. https://doi.org/10.3390/s22186941

Note that from the first issue of 2016, this journal uses article numbers instead of page numbers. See further details here.

Article Metrics

Back to TopTop