Next Article in Journal
Pedestrian Detection Algorithm for Intelligent Vehicles in Complex Scenarios
Previous Article in Journal
Design of an Edge-Detection CMOS Image Sensor with Built-in Mask Circuits
Previous Article in Special Issue
Object-Based Thermal Image Segmentation for Fault Diagnosis of Reciprocating Compressors
Open AccessArticle

Automated Calibration System for Digital Multimeters Not Equipped with a Communication Interface

Faculty of Mechanical and Electrical Engineering, Polish Naval Academy, 81-127 Gdynia, Poland
*
Author to whom correspondence should be addressed.
Sensors 2020, 20(13), 3650; https://doi.org/10.3390/s20133650
Received: 8 May 2020 / Revised: 17 June 2020 / Accepted: 26 June 2020 / Published: 29 June 2020
This article is focused on the calibration of digital multimeters, in which the concept and practical solutions for stations with software for automatic calibration are presented. This paper also presents the general structure of the measuring system, the application scheme, and the technical implementation of measuring stations, together with the software. View Full-Text
Keywords: automation; calibration; dot recognition automation; calibration; dot recognition
Show Figures

Figure 1

MDPI and ACS Style

Grzeczka, G.; Klebba, M. Automated Calibration System for Digital Multimeters Not Equipped with a Communication Interface. Sensors 2020, 20, 3650.

Show more citation formats Show less citations formats
Note that from the first issue of 2016, MDPI journals use article numbers instead of page numbers. See further details here.

Article Access Map by Country/Region

1
Search more from Scilit
 
Search
Back to TopTop