Next Article in Journal
Viscoelastic Rheological Behaviors of Polypropylene and LMPP Blends
Next Article in Special Issue
Improved Wear-Resistant Performance of Epoxy Resin Composites Using Ceramic Particles
Previous Article in Journal
Effect of Sodium Hypochlorite Concentration in Continuous Chelation on Dislodgement Resistance of an Epoxy Resin and Hydraulic Calcium Silicate Sealer
Previous Article in Special Issue
Effect of Processing Techniques on the Microstructure and Mechanical Performance of High-Density Polyethylene
 
 
Font Type:
Arial Georgia Verdana
Font Size:
Aa Aa Aa
Line Spacing:
Column Width:
Background:
Article

The Effects of Iron Rust on the Ageing of Woods and Their Derived Pulp Paper

1
Restoration Department, High Institute of Tourism, Hotel Management and Restoration, Abukir, Alexandria 21526, Egypt
2
Conservation Department, Faculty of Archaeology, Aswan University, Aswan 81528, Egypt
3
Forestry and Wood Technology Department, Faculty of Agriculture (EL-Shatby), Alexandria University, Alexandria 21545, Egypt
4
General Laboratory and Research, Misr Edfu Pulp Writing and Printing Paper Co. (MEPPCO), Aswan 81656, Egypt
5
Department of Materials Engineering and Chemistry, Faculty of Civil Engineering, Czech Technical University in Prague, Thákurova 7, 166 29 Prague 6, Czech Republic
6
Restoration Department, Faculty of Archaeology, Cairo University, Giza 12613, Egypt
*
Author to whom correspondence should be addressed.
Polymers 2021, 13(20), 3483; https://doi.org/10.3390/polym13203483
Submission received: 19 September 2021 / Revised: 6 October 2021 / Accepted: 8 October 2021 / Published: 11 October 2021
(This article belongs to the Special Issue Durability and Degradation of Polymeric Materials)

Abstract

The accelerated ageing of wood in terms of heating or iron rusting has a potential effect on the physio-mechanical, chemical and biological properties of wood. The effects of accelerated ageing on the mechanical, physical and fungal activity properties of some wood materials (Schinus terebinthifolius, Erythrina humeana, Tectona grandis, Pinus rigida and Juglans nigra) were studied after several cycles of heating and iron rusting. The fungal activity was assayed against the growth of Aspergillus terreus, Aspergillus niger, Fusarium culmorum and Stemphylium solani. In addition, the mechanical and optical properties of paper sheets produced from those wood pulps by means of Kraft cooking were evaluated. The mechanical and chemical properties of the studied wood species were affected significantly (p < 0.05) by the accelerated ageing, compared to control woods. With Fourier transform infrared (FTIR) spectroscopy, we detected an increase in the intensity of the spectra of the functional groups of cellulose in the heated samples, which indicates an increase in cellulose content and decrease in lignin content, compared to other chemical compounds. For pulp properties, woods treated by heating showed a decrease in the pulp yield. The highest significant values of tensile strength were observed in pulp paper produced from untreated, heated and iron-rusted P. rigida wood and they were 69.66, 65.66 and 68.33 N·m/g, respectively; we calculated the tear resistance from pulp paper of untreated P. rigida (8.68 mN·m2/g) and T. grandis (7.83 mN·m2/g) and rusted P. rigida (7.56 mN·m2/g) wood; we obtained the values of the burst strength of the pulp paper of untreated woods of P. rigida (8.19 kPa·m2/g) and T. grandis (7.49 kPa·m2/g), as well as the fold number of the pulp paper of untreated, heated and rusted woods from P. rigida, with values of 195.66, 186.33 and 185.66, respectively. After 14 days from the incubation, no fungal inhibition zones were observed. Accelerated ageing (heated or iron-rusted) produced significant effects on the mechanical and chemical properties of the studied wood species and affected the properties of the produced pulp paper.
Keywords: iron rust; mechanical properties; wood pulp; Fourier transform infrared spectroscopy; accelerated ageing iron rust; mechanical properties; wood pulp; Fourier transform infrared spectroscopy; accelerated ageing

Share and Cite

MDPI and ACS Style

Abo Elgat, W.A.A.; Taha, A.S.; Salem, M.Z.M.; Fares, Y.G.D.; Böhm, M.; Mohamed, M.F.; Nasser, R.A.; Pommer, V. The Effects of Iron Rust on the Ageing of Woods and Their Derived Pulp Paper. Polymers 2021, 13, 3483. https://doi.org/10.3390/polym13203483

AMA Style

Abo Elgat WAA, Taha AS, Salem MZM, Fares YGD, Böhm M, Mohamed MF, Nasser RA, Pommer V. The Effects of Iron Rust on the Ageing of Woods and Their Derived Pulp Paper. Polymers. 2021; 13(20):3483. https://doi.org/10.3390/polym13203483

Chicago/Turabian Style

Abo Elgat, Wael A. A., Ayman S. Taha, Mohamed Z. M. Salem, Yahia G. D. Fares, Martin Böhm, Mourad F. Mohamed, Ramadan A. Nasser, and Vojtěch Pommer. 2021. "The Effects of Iron Rust on the Ageing of Woods and Their Derived Pulp Paper" Polymers 13, no. 20: 3483. https://doi.org/10.3390/polym13203483

APA Style

Abo Elgat, W. A. A., Taha, A. S., Salem, M. Z. M., Fares, Y. G. D., Böhm, M., Mohamed, M. F., Nasser, R. A., & Pommer, V. (2021). The Effects of Iron Rust on the Ageing of Woods and Their Derived Pulp Paper. Polymers, 13(20), 3483. https://doi.org/10.3390/polym13203483

Note that from the first issue of 2016, this journal uses article numbers instead of page numbers. See further details here.

Article Metrics

Back to TopTop