Search Results (2)

Walking-induced vibration control in wood floors is a critical issue attracting the attention of many researchers and engineers. This paper presents an experimental study applying static deflection tests, modal tests, and pedestrian load tests to a series of full-scale 12 m span tooth plates connected to wood truss joist floors with strongbacks and partition walls. A comparison of the calculation error of vibration parameters between the theoretical formula and a numerical model was also conducted. The results show that strongbacks and partition walls effectively reduce both the vertical displacement and the root means acceleration at the center of the floor under pedestrian load but increases the natural frequency. The partition wall can achieve a better vibration-reduction effect than strongbacks. The error of the finite element model is higher than that of the theoretical formula. Using the theoretical formula in engineering wood floor design is recommended. Full article

This paper provides an experimental study and computer modeling analysis of vibration performance of full-scale wood truss joist floors, related to the static deflection and vibration mode/frequency and single-person-induced vibration. The vibration behavior of full-scale truss joist floors was investigated and the influences of the strongbacks on the vibration behavior were assessed. The results showed that the simulated predictions agreed well with the measured results. Strongbacks do not significantly affect the fundamental frequency of the truss joist floors but influence the second and third modal frequencies. The use of strongback rows at mid-span effectively decreased the maximum deformation of point loading at floor center. The effect of adding strongbacks at one-third of each span on decreasing maximum deformation at the floor center was minimal. The case of walking parallel to the joist produced higher acceleration response at the floor center than that of walking perpendicular to the joist. The closer the placements of strongbacks were to the mid-span, the more significant reduction of the vibration at floor center was. Two strongback rows at mid-span performed the best effect on reduction of vibration response at floor center. However, the use of strongbacks had limits of reduction peak acceleration of the sheathing between the joists. The study provides a valuable guide for future vibration serviceability study and design optimization of wood truss joist floors. Full article