Search Results (3)

The differential propagation phase (Φ_DP) of X-band dual-polarization weather radar (including X-band dual-polarization phased-array weather radar, X-PAR) is important for estimating precipitation and classifying hydrometeors. However, the measured differential propagation phase contains the backscatter differential phase (δ), which poses difficulties for the application of the differential propagation phase from X-band radars. This paper presents the following: (1) the simulation and characteristics analysis of the backscatter differential phase based on disdrometer DSD (raindrop size distribution) measurement data; (2) an improved method of the specific differential propagation phase (K_DP) estimation based on linear programming and backscatter differential phase elimination; (3) the effect of backscatter differential phase elimination on the specific differential propagation phase estimation of X-PAR. The results show the following: (1) For X-band weather radar, the raindrop equivalent diameters D > 2 mm may cause a backscatter differential phase between 0 and 20°; in particular, the backscatter differential phase varies sharply with raindrop size between 3.2 and 4.5 mm. (2) Using linear programming or smoothing filters to process the differential propagation phase could suppress the backscatter differential phase, but it is hard to completely eliminate the effect of the backscatter differential phase. (3) Backscatter differential phase correction may improve the calculation accuracy of the specific differential propagation phase, and the optimization was verified by the improved self-consistency of polarimetric variables, correlation between specific differential propagation phase estimations from S- and X-band radar and the accuracy of quantitative precipitation estimation. The X-PAR deployed in Shenzhen showed good observation performance and the potential to be used in radar mosaics with S-band weather radar. Full article

X-band dual-polarization phased-array weather radars (X-PARs) have been used in South China extensively. Eliminating the attenuation and system bias of X-band radar data is the key to utilizing the advantage of X-PAR networks. In this paper, the disdrometer raindrop-size distribution (DSD) measurements are used to calculate the radar polarimetric variables and analyze the characteristics of precipitation attenuation. Furthermore, based on the network of S-band dual-polarization Doppler weather radar (S-POL) and X-PARs, an attenuation-correction method for X-PAR reflectivity is proposed with S-POL constraints in view of the radar-mosaic requirements of a multi-radar network. Linear programming is used to calculate the attenuation-correction parameters of different rainfall areas, which realizes the attenuation correction for X-PAR. The results show that the attenuation-correction parameters simulated based on the disdrometer DSD vary with different precipitation classification; the attenuation-corrected reflectivity of X-PARs is consistent with S-POL and can realize a more precise observation of the evolution of the convective system. Compared with previous attenuation-correction methods with constant correction parameters, the improved method can reduce the deviation between X-PAR reflectivity and that of S-POL in heavy rainfall areas and areas of strong attenuation. The method proposed in this paper is stable and effective. After effective quality control, it is found that the X-PAR network deployed in South China observes data accurately and is consistent with S-POL; thus, it is expected to achieve high temporal–spatial resolution within a radar mosaic. Full article

The quality of radar data is crucial for its application. In particular, before radar mosaic and quantitative precipitation estimation (QPE) can be conducted, it is necessary to know the quality of polarimetric parameters. The parameters include the horizontal reflectivity factor, Z_H; the differential reflectivity factor, Z_DR; the specific differential phase, K_DP; and the correlation coefficient, ρ_HV. A novel radar data quality index (RQI) is specifically developed for the Chinese polarimetric radars. Not only the influences of partial beam blockages and bright band upon radar data quality, but also those of bright band correction performance, signal-to-noise ratio, and non-precipitation echoes are considered in the index. RQI can quantitatively describe the quality of various polarimetric parameters. A new radar mosaic QPE algorithm based on RQI is presented in this study, which can be used in different regions with the default values adjusted according to the characteristics of local radar. RQI in this algorithm is widely used for high-quality polarimetric radar data screening and mosaic data merging. Bright band correction is also performed to errors of polarimetric parameters caused by melting ice particles for warm seasons in this algorithm. This algorithm is validated by using nine rainfall events in Guangdong province, China. Major conclusions are as follows. Z_H, Z_DR, and K_DP in bright band become closer to those under bright band after correction than before. However, the influence of K_DP correction upon QPE is not as good as that of Z_H and Z_DR correction in bright band. Only Z_H and Z_DR are used to estimate precipitation in the bright band affected area. The new mosaic QPE algorithm can improve QPE performances not only in the beam blocked areas and the bright band affected area, which are far from radars, but also in areas close to the two radars. The sensitivity tests show the new algorithm can perform well and stably for any type of precipitation occurred in warm seasons. This algorithm lays a foundation for regional polarimetric radar mosaic precipitation estimation in China. Full article