Search Results (3)

The Takagi-Sugeno (T-S) fuzzy control is a nonlinear method that uses a combination of linear controllers as its control law. This method has been applied in various fields of scientific research: buck converters, biomedicine, civil engineering, etc. To the best of the authors’ knowledge, although works on traditional fuzzy control and optical interferometry have already been published, this is the first time that T-S fuzzy (specifically) is applied to demodulate interferometry signals. Through a proof-of-concept experiment, the paper describes the fusion of an open-loop interferometer with an external closed-loop digital observer based on T-S fuzzy (both simple and inexpensive), which actuates like a closed-loop interferometer (but without its drawbacks). The observer design is based on stability conditions using linear matrix inequalities (LMIs) solutions. The system is maintained at the optimal ${90}^{\circ }$ operation point (compensating for environmental drifts) and enables the demodulation of optical phase signals with low modulation index. Simulations and measurements were performed by using a Michelson interferometer, verifying that the method demodulates signals up to $\pi /2$ rad amplitudes and higher than 100 Hz frequencies (with maximum error of 0.45%). When compared to the important arc tangent method, both presented the same frequency response for the test PZT actuator. Full article

A controllable particle size mono-dispersing nanofluid system has been developed to address the challenges of low porosity and low-permeability in low to ultra-low-permeability reservoirs. This system combines high dispersion stability with enhanced oil recovery performance, and its effectiveness in improving recovery rates in low-permeability reservoirs, where conventional chemical flooding is ineffective, has been well demonstrated. Using the in situ method to prepare monodispersed nano-silica particles, the effects of the water concentration, ammonia concentration, and silica precursor concentration on the morphology, particle size, and formation time of the silica spherical particles were analyzed. Building on this foundation, a partially hydrophobic modified nano-silica oil displacement fluid was synthesized in situ. The system’s dispersion stability, ability to reduce oil-water interfacial tension, and capacity to alter rock wettability were evaluated. Core physical models were used to evaluate the oil displacement efficiency and the permeability applicability limits of the self-dispersing nano-silica oil displacement system. The experiments confirmed that the particle size distribution of the self-dispersing nano-silica oil displacement system can be controlled within a range of 10 nm to 300 nm. The nanofluids exhibited excellent stability, effectively altering the rock wettability from oil-wet to water-wet and reducing the oil-water interfacial tension to approximately 10⁻¹ mN/m. The nano-displacement system increased the recovery rate of the low permeability reservoirs by more than 17%. The in situ modification method used to prepare these self-dispersing nanoparticles provides valuable insights for synergistic enhancement of recovery when combined with other systems, such as surfactants and CO₂. This approach also opens up new possibilities and drives further development in the field of nano-enhanced oil recovery chemistry. Full article

This work determines the coded control of a sectional electroelastic engine at the elastic–inertial load for nanomechatronics systems. The expressions of the mechanical and adjustment characteristics of a sectional electroelastic engine are obtained using the equations of the electroelasticity and the mechanical load. A sectional electroelastic engine is applied for coded control of nanodisplacement as a digital-to-analog converter. The transfer function and the transient characteristics of a sectional electroelastic engine at elastic–inertial load are received for nanomechatronics systems. Full article