Search Results (2)

In the last decades, the notion of including excipients in the formulations, as inert substances aiding production processes, has changed and they are recently viewed as multifunctional discrete entities. It is now well documented that excipients serve several roles, spreading from the stabilization and modified release, to providing biocompatible properties and targeting moieties. The aim of this study was to develop matrix-based oral drug delivery systems of bupropion hydrochloride (BUP·HCl) and naltrexone hydrochloride (NTX·HCl), suitable for releasing these active substances in a modified manner, providing a stable level of drug release, which is simultaneously therapeutically effective and non-toxic, thus reducing side effects, after a single dose administration, throughout the gastrointestinal tract. The new formulations, employing hydroxypropylmethycellulose (HPMC K15M) (a cellulosic polymer, which, generally hydrates to form a gelatinous layer that is critical to prevent wetting and rapid drug release from the matrices), poly(methacylic acid-co-ethyl acrylate) 1:1 (Eudragit^® L100-55: effective for site specific drug delivery in intestine), poly(ethylene oxide) (PEO) (7 × 10⁶: a high molecular weight polymer, water-soluble, in micro-granular powder form), as the rate controlling polymers, were chosen to lead to a “soothing out” release pattern of these drugs, at 0 ≤ t ≤ 120 min. Moreover, the release of the two drugs from the ulvan-based tablets, was found to follow the desired profile, throughout the entire course of the dissolution experiments. Full article

The performance of the novel chitin metal silicate (CMS) co-precipitates as a single multifunctional excipient in tablet formulation using direct compression and wet granulation methods is evaluated. The neutral, acidic, and basic drugs Spironolactone (SPL), ibuprofen (IBU) and metronidazole (MET), respectively, were used as model drugs. Commercial Aldactone^®, Fleximex^® and Dumazole^® tablets containing SPL, IBU and MET, respectively, and tablets made using Avicel^® 200, were used in the study for comparison purposes. Tablets of acceptable crushing strength (>40 N) were obtained using CMS. The friability values for all tablets were well below the maximum 1% USP tolerance limit. CMS produced superdisintegrating tablets (disintegration time < 1 min) with the three model drugs. Regarding the dissolution rate, the sequence was as follow: CMS > Fleximex^® > Avicel^® 200, CMS > Avicel^® 200 > Dumazole^® and Aldactone^® > Avicel^® 200 > CMS for IBU, MET and SPL, respectively. Compressional properties of formulations were analyzed using density measurements and the compression Kawakita equation as assessment parameters. On the basis of DSC results, CMS co precipitates were found to be compatible with the tested drugs. Conclusively, the CMS co-precipitates have the potential to be used as filler, binder, and superdisintegrant, all-in-one, in the design of tablets by the direct compression as well as wet granulation methods. Full article