Search Results (5)

Background: Ketamine HCl, an FDA-approved therapeutic, is administered through various routes, including intranasal delivery. Administering an adequate therapeutic dose of intranasal ketamine HCl is challenging due to the limited volume that can be delivered intranasally given the current commercially available concentrations. Objectives: This study investigates solubilizing strategies to enhance the aqueous solubility of ketamine HCl for intranasal administration. Methods: We assessed the solubility profile of ketamine HCl by evaluating factors such as pH, co-solvents, and surfactants. Additionally, we developed and validated a UV-Vis spectroscopy method for ketamine HCl analysis. Results: Our solubility screening in various organic co-solvents revealed the following order of effectiveness in enhancing solubility: methanol > water > propylene glycol > ethanol > dimethyl sulfoxide (DMSO) > N-methyl-2-pyrrolidone (NMP). Despite methanol’s superior solubility, its potential toxicity, coupled with the relatively lower effectiveness of other solvents compared to water, suggests that a co-solvency approach is not advantageous for ketamine HCl. We found that ketamine HCl solubility increased with medium acidity, with pH 3.5 being the optimal for further formulation studies. The impact of pharmaceutical surfactants on ketamine HCl solubility at an acidic pH was also evaluated. Surfactants tested included SDS, PEG 400, PVP, Tween 20, poloxamer 188, and lecithin. Notably, PEG 400 and PVP reduced solubility due to a salting-out effect, whereas Tween 80, lecithin, and poloxamer 188 slightly improved solubility through micelle formation. Among the surfactants tested, 1% SDS emerged as the most effective in enhancing ketamine HCl solubility. Conclusions: These outcomes highlight the potential of these solubilization strategies to address the solubility limitations of ketamine HCl, enabling the preparation of highly concentrated ketamine HCl formulations for intranasal delivery. Full article

In this study, a novel floating, controlled-release and core-shell oral tablet of ketamine hydrochloride (HCl) was produced using a dual extrusion by 3D printing method. A mixture of Soluplus^® and Eudragit^® RS-PO was extruded by a hot-melt extrusion (HME) nozzle at 150–160 °C to fabricate the tablet shell, while a second nozzle known as a pressure-assisted syringe (PAS) extruded the etamine HCl in carboxymethyl cellulose gel at room temperature (25 °C) inside the shell. The resulting tablets were optimized based on the United States pharmacopeia standards (USP) for solid dosage forms. Moreover, the tablet was characterized using Fourier-transform infrared (FTIR) spectrum, scanning electron microscopy (SEM), differential scanning calorimetry (DSC), and buoyancy techniques. The results showed a desired dissolution profile for a 100% infill optimized tablet with total drug release (100%) during 12 h. Weight variation and content uniformity of the tablets achieved the USP requirements. SEM micrographs showed a smooth surface with acceptable layer diameters. According to the FTIR analysis, no interference was detected among peaks. Based on DSC analysis, the crystallinity of ketamine HCl did not change during melt extrusion. In conclusion, the floating controlled-release 3D-printed tablet of ketamine HCl can be a promising candidate for management of refractory depressions and chronic pain. Additionally, the additive manufacturing method enables the production of patient-tailored dosage with tunable-release kinetics for personalized medicine in point-of care setting. Full article

Vancomycin is a commonly used antibiotic in hospital settings, especially against Methicillin-resistant staphylococcus aureus (MRSA). One of the major adverse events of vancomycin use in adults is kidney injury. The drug concentration, specifically the area under the concentration curve, predicts kidney injury in adults receiving vancomycin. To attempt to reduce vancomycin-induced nephrotoxicity, we have successfully encapsulated vancomycin in polyethylene glycol-coated liposomes (PEG-VANCO-lipo). We have previously carried out in vitro cytotoxicity studies on kidney cells using PEG-VANCO-lipo and found it to be minimally toxic compared to the standard vancomycin. In this study, we have dosed male adult rats with PEG-VANCO-lipo or vancomycin HCl and compared plasma vancomycin concentrations and KIM-1 as an injury biomarker in rat urine. Male Sprague Dawley rats (350 ± 10 g) were administered vancomycin (n = 6) or PEG-VANCO-lipo (n = 6) 150 mg/kg/day for three days using an IV infusion in the left jugular vein catheter. Blood was collected for plasma at 15, 30, 60, 120, 240, and 1440 min after the first and the last IV dose. Urine was collected 0–2, 2–4, 4–8, and 8–24 h after the first and the last IV infusions using metabolic cages. The animals were observed for three days after the last compound administration. Vancomycin was quantified in plasma by LC-MS/MS. Urinary KIM-1 analysis was done by using an ELISA kit. Three days after the last dose, under terminal anesthesia with IP ketamine (65–100 mg/kg) and xylazine (7–10 mg/kg), rats were euthanized. Vancomycin urine and kidney concentrations and KIM-1 were lower on day three in the PEG-Vanco-lipo group compared to the vancomycin group (p < 0.05, ANOVA and/or t-test). There was a significant reduction in plasma vancomycin concentration on day one and day three (p < 0.05, t-test) in the vancomycin group compared to the PEG-VANCO-lipo group. Vancomycin-loaded PEGylated liposomes resulted in lower levels of kidney injury, as noted by a decrease in KIM-1 values. Moreover, longer circulation in plasma with increased concentration in plasma as opposed to the kidney was observed with the PEG-VANCO-lipo group. The results indicate the high potential of PEG-VANCO-lipo in decreasing the nephrotoxicity of vancomycin clinically. Full article

Excessive Ca²⁺ currents via N-methyl-D-aspartate receptors (NMDARs) have been implicated in many disorders. Uncompetitive NMDAR channel blockers are an emerging class of drugs in clinical use for major depressive disorder (MDD) and other neuropsychiatric diseases. The pharmacological characterization of uncompetitive NMDAR blockers in clinical use may improve our understanding of NMDAR function in physiology and pathology. REL-1017 (esmethadone-HCl), a novel uncompetitive NMDAR channel blocker in Phase 3 trials for the treatment of MDD, was characterized together with dextromethorphan, memantine, (±)-ketamine, and MK-801 in cell lines over-expressing NMDAR subtypes using fluorometric imaging plate reader (FLIPR), automated patch-clamp, and manual patch-clamp electrophysiology. In the absence of Mg²⁺, NMDAR subtypes NR1-2D were most sensitive to low, sub-μM glutamate concentrations in FLIPR experiments. FLIPR Ca²⁺ determination demonstrated low μM affinity of REL-1017 at NMDARs with minimal subtype preference. In automated and manual patch-clamp electrophysiological experiments, REL-1017 exhibited preference for the NR1-2D NMDAR subtype in the presence of 1 mM Mg²⁺ and 1 μM L-glutamate. Tau off and trapping characteristics were similar for (±)-ketamine and REL-1017. Results of radioligand binding assays in rat cortical neurons correlated with the estimated affinities obtained in FLIPR assays and in automated and manual patch-clamp assays. In silico studies of NMDARs in closed and open conformation indicate that REL-1017 has a higher preference for docking and undocking the open-channel conformation compared to ketamine. In conclusion, the pharmacological characteristics of REL-1017 at NMDARs, including relatively low affinity at the NMDAR, NR1-2D subtype preference in the presence of 1 mM Mg²⁺, tau off and degree of trapping similar to (±)-ketamine, and preferential docking and undocking of the open NMDAR, could all be important variables for understanding the rapid-onset antidepressant effects of REL-1017 without psychotomimetic side effects. Full article

Subcutaneous (SC) ketamine has been found to be effective in pain management, though reports of injection site irritation and sterile abscesses exist with currently available ketamine HCl formulations. Such adverse SC reactions are commonly associated with low pH, high osmolality and/or high injection volumes. An optimal SC formulation of ketamine would thus have a pH and osmolality close to physiological levels, without compromising on concentration and, thus, injection volume. Such a formulation should also be buffered to maintain the pH at the acceptable level for extended time periods. As many of these physicochemical properties are interrelated, achieving these aims represented a significant challenge in formulation development. We describe the development of a novel Captisol^®-based formulation strategy to achieve an elevated pH, isosmotic and buffered formulation of ketamine (hence, three birds, one excipient) without compromising on concentration. This strategy has the potential to be readily adapted to other amine-based APIs. Full article