Search Results (4)

The term “nanosheets” has been coined recently to describe supported and free-standing “ultrathin film” materials, with thicknesses ranging from a single atomic layer to a few tens of nanometers. Owing to their physicochemical properties and their large surface area with abundant accessible active sites, nanosheets (NSHs) of inorganic materials such as Au, amorphous carbon, graphene, and boron nitride (BN) are considered ideal building blocks or scaffolds for a wide range of applications encompassing electronic and optical devices, membranes, drug delivery systems, and multimodal contrast agents, among others. A wide variety of synthetic methods are employed for the manufacturing of these NSHs, and they can be categorized into (1) top-down approaches involving exfoliation of layered materials, or (2) bottom-up approaches where crystal growth of nanocomposites takes place in a liquid or gas phase. Of note, polymer template liquid exfoliation (PTLE) methods are the most suitable as they lead to the fabrication of high-performance and stable hybrid NSHs and NSH composites with the appropriate quality, solubility, and properties. Moreover, PTLE methods allow for the production of stimulus-responsive NSHs, whose response is commonly driven by a favorable growth in the appropriate polymer chains onto one side of the NSHs, resulting in the ability of the NSHs to roll up to form nanoscrolls (NSCs), i.e., open tubular structures with tunable interlayer gaps between their walls. On the other hand, this review gives insight into the potential of the stimulus-responsive nanostructures for biosensing and controlled drug release systems, illustrating the last advances in the PTLE methods of synthesis of these nanostructures and their applications. Full article

The coupled momenta induced by thermal effects near interfaces cause complex three-dimensional flow structures, called thermocapillary flow or Marangoni convection. Thermocapillary convection is crucial for crystal growth quality, and the mainstream method used to study thermocapillary convection is the half-zone liquid bridge model. This paper designs a gas–liquid two-phase system and reports the numerical results on the instability and associated roll structures of thermocapillary convection in half-zone liquid bridge under microgravity environment. The gas and liquid transferred momentum and energy through the free surface. The geometry of interest is high aspect ratio (AR) silicone oil suspended between coaxial disks heated differentially. It was found that with the increase in AR, the vortex of thermocapillary convection gradually moves to the upper disk at the steady state. In the range of 2 < AR < 2.5, the vortex cell splits from 1 to 2, and the distance between the vortex center increases with the increase in AR. The flow field after the onset of instability exhibits a traveling wave with wave number m = 1 when AR ≤ 3 and exhibits a standing wave with wave number m = 1 when AR ≥ 3.5. Full article

Induced or spontaneous chirality in natural systems is an intriguing issue. In recent years, a lot of attention has been focused on chirality of chromonic liquid crystals, a class of materials that is able to self-assemble in columnar structures. However, the mechanism involved in the arising of chirality in these materials, that starts at the molecular level and controls the supramolecular structure, is poorly understood; however, it is certainly affected by ionic strength. In this work we present the results obtained doping Cromolyn, a chromonic material, with a strong helical-twisting-power peptide, and confining it in a spherical geometry. We demonstrate, by means of optical polarized microscopy and structural analysis, that both the geometrical constraint and the presence of the chiral dopant enhance the chiral effect; we also demonstrate that they favor the rise of a highly ordered helical superstructure, that may be optimized upon adding an ionic dye to the system. Finally, we report a procedure for the preparation of free-standing polymeric films, embedding and preserving the microspheres, and paving the way for the creation of biocompatible and eco-friendly optical devices to be used in the sensor and anticounterfeiting fields. Full article

The problem of predicting structural and dynamic behavior associated with thin smectic films, both deposited on a solid surface or stretched over an opening, when the temperature is slowly increased above the bulk transition temperature towards either the nematic or isotropic phases, remains an interesting one in the physics of condensed matter. A useful route in studies of structural and optical properties of thin smectic films is provided by a combination of statistical–mechanical theories, hydrodynamics of liquid crystal phases, and optical and calorimetric techniques. We believe that this review shows some useful routes not only for the further examining of the validity of a theoretical description of thin smectic films, both deposited on a solid surface or stretched over an opening, but also for analyzing their structural, optical, and dynamic properties. Full article