Sign in to use this feature.

Years

Between: -

Subjects

remove_circle_outline

Journals

Article Types

Countries / Regions

Search Results (2)

Search Parameters:
Authors = Supat Klinkiew

Order results
Result details
Results per page
Select all
Export citation of selected articles as:
15 pages, 6279 KiB  
Article
Development of a Combined Horizontal and Vertical Correcting Magnet for Siam Photon Source II
by Supachai Prawanta, Prapaiwan Sunwong, Pariwat Singthong, Thongchai Leetha, Pajeeraphorn Numanoy, Warissara Tangyotkhajorn, Apichai Kwankasem, Visitchai Sooksrimuang, Sukho Kongtawong and Supat Klinkiew
Particles 2023, 6(4), 898-912; https://doi.org/10.3390/particles6040058 - 13 Oct 2023
Cited by 1 | Viewed by 1994
Abstract
A prototype of a combined horizontal and vertical correcting magnet was designed and fabricated for the 3 GeV storage ring of Siam Photon Source II, which will be the second synchrotron light source in Thailand. The magnet will be employed for fast-orbit feedback [...] Read more.
A prototype of a combined horizontal and vertical correcting magnet was designed and fabricated for the 3 GeV storage ring of Siam Photon Source II, which will be the second synchrotron light source in Thailand. The magnet will be employed for fast-orbit feedback correction, with a required magnetic field integral of approximately 8 Tesla.mm. The magnet pole and yoke were manufactured using laminated silicon steel to minimize hysteresis and eddy current losses during operation. Magnet modeling and magnetic field calculations were performed using Opera-3D. The size of the gap between the magnet poles is limited by the size of the vacuum chamber over which the magnet will be installed; in this case, it was designed to be 65 mm. Mechanical analysis of the structure of the magnet was performed using SOLIDWORKS and ANSYS. Magnetic field measurements were obtained using the Hall probe technique. The entire prototype, from its design to manufacturing and measurement, was completed in-house. This design will be appropriate for application at the Siam Photon Source II storage ring. Full article
(This article belongs to the Special Issue Generation and Application of High-Power Radiation Sources)
Show Figures

Figure 1

10 pages, 2897 KiB  
Article
Development of Type A Quadrupole Magnet for Siam Photon Source II
by Supachai Prawanta, Thongchai Leetha, Pariwat Singthong, Pajeeraphorn Numanoy, Apichai Kwankasem, Visitchai Sooksrimuang, Chaiyut Preecha, Supat Klinkiew and Prapaiwan Sunwong
Particles 2023, 6(2), 664-673; https://doi.org/10.3390/particles6020039 - 9 Jun 2023
Viewed by 2887
Abstract
A prototype of a type A quadrupole magnet has been designed and manufactured for the 3 GeV storage ring of Siam Photon Source II, the second synchrotron light source in Thailand. The required quadrupole gradient is 51 T/m with the magnet effective length [...] Read more.
A prototype of a type A quadrupole magnet has been designed and manufactured for the 3 GeV storage ring of Siam Photon Source II, the second synchrotron light source in Thailand. The required quadrupole gradient is 51 T/m with the magnet effective length being 162 mm. Magnet modeling and magnetic field calculation were performed using Radia and Opera-3D. The bore radius of the magnet is 16 mm. The magnet will be operated at the excitation of 5544 A-turns. A mechanical analysis of the magnet structure was performed in SOLIDWORKS and ANSYS, where the maximum deformation of 0.003 mm was found at the magnet poles, and the first-mode natural frequency was higher than 100 Hz. The magnet yoke is made of AISI 1006 low-carbon steel with a fabrication tolerance of ±0.020 mm. Magnet coils are water-cooled and made of high-purity copper. The temperature rise of the coils was below 3.0 °C at the maximum excitation of 6664 A-turns, which is 20% above the operating point. Magnetic field measurement was carried out using the Hall probe technique. The measured magnetic field and coil temperature of the prototype show good agreement with the calculations. Full article
(This article belongs to the Special Issue Generation and Application of High-Power Radiation Sources)
Show Figures

Figure 1

Back to TopTop