Next Article in Journal
Laser Annealing of Sb2Te3 2D Layers towards Nonlinear Optical Applications
Previous Article in Journal
Optical Properties of Tungsten: A Parametric Study to Characterize the Role of Roughness, Surface Composition and Temperature
 
 
Article
Peer-Review Record

Frequency Alteration Built on an Electro-Optical Sampling SOA–MZI Using a Differential Modulation Schema

Optics 2022, 3(3), 225-233; https://doi.org/10.3390/opt3030022
by Hassan Termos * and Ali Mansour
Reviewer 1: Anonymous
Reviewer 2:
Optics 2022, 3(3), 225-233; https://doi.org/10.3390/opt3030022
Submission received: 1 June 2022 / Revised: 1 July 2022 / Accepted: 7 July 2022 / Published: 11 July 2022
(This article belongs to the Special Issue Fiber Communication Technology: Latest Advances and Prospects)

Round 1

Reviewer 1 Report

The article "Frequency Mixing Based on an Electro-Optical SOA-MZI Sampling Mixer Using a Differential Modulation Schema" by Hassan Termos and Ali Mansour desribes simulation and development of frequency mixing device based on electro-optical up-converter utilizing a semiconductor optical amplifier Mach–Zehnder interferometer. The overall article design looks sound and the obtained results are well-presented, however, the introduction part contain mostly references on the same authors. I would suggest to extend it including works by the other research groups or describe why the only one group is working in this direction and have no concurents. The article also requires some minor proofreading, so I suggest to accept it after the minor revision extending the introduction part of the article.

Author Response

Hi Professor,

I just sent you the response to your report.

Thank you for your notes.

Author Response File: Author Response.pdf

Reviewer 2 Report

A real and simulated study of an electro-optical up-converter utilizing a semiconductor optical amplifier Mach–Zehnder interferometer (SOA-MZI) sampling mixer along with the differential modulation schema is presented in this paper, some comments as follows:

1.Why the author use the up-converter, it should be decribed clearly.

2.Effiviency should be discussed.

3.The comparison should given with a table in quantitity.

4.More relevant publication should be discussed such as DOI: 10.1016/j.isatra.2022.02.019

5.The figures and english writing should be checked such as Fig.3, too big.

Author Response

Hi Professor,

I just sent you the response to your comments.

Thank you for your valuable comments that help me improve the entire manuscript.

Author Response File: Author Response.pdf

Round 2

Reviewer 2 Report

An electro-optical up-coan electro-optical up-converter is used in the system design, the advantages should be discussed with exiisted converter circuit such asDOI: 10.1016/j.isatra.2022.02.019, 2022.

Author Response

Dear Prof,

I just replied to your comment.

Best regards,

Hassan Termos

Ph.D. in Photonics

Author Response File: Author Response.docx

Back to TopTop