Skip to Content
MetalsMetals
  • Article
  • Open Access

13 June 2019

12 Pages

Mechanical Properties and Microstructure of W-6Ni-4Co Alloy by a Two-Step Sintering Process

,
,
and
School of Materials Science and Engineering, Shaanxi University of Technology, Hanzhong 723001, China
*
Author to whom correspondence should be addressed.
This article belongs to the Special Issue Advanced Tungsten Materials

Abstract

The mechanical properties and microstructure of W-6Ni-4Co alloy through solid phase sintering and two-step sintering process were investigated. The results demonstrated that the particle sizes of W-6Ni-4Co alloy milled powders increased firstly and decreased later during a mechanical alloying process. The shape of alloy milled powders affected that of grains in alloy by solid phase sintering. The shape of W-rich particles in the alloys changed from stripes to network, to polygonal and to subsphaeroidal finally during two-step sintering process. The mechanical properties could be attributed to the densification and microstructure of alloys, and increased during two-step sintering with short dwelling time.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.