Optimization of Non-Uniform Deformation on Piezoelectric Circular Diaphragm Energy Harvester with a Ring-Shaped Ceramic Disk
Abstract
:1. Introduction
2. Materials and Methods
3. Results and Discussion
4. Conclusions
Author Contributions
Funding
Conflicts of Interest
References
- Fang, H.-B.; Liu, J.-Q.; Xu, Z.-Y.; Dong, L.; Wang, L.; Chen, D.; Cai, B.-C.; Liu, Y. Fabrication and performance of MEMS-based piezoelectric power generator for vibration energy harvesting. Microelectron. J. 2006, 37, 1280–1284. [Google Scholar] [CrossRef]
- Lin, S.-C.; Wu, W.-J. Fabrication of PZT MEMS energy harvester based on silicon and stainless-steel substrates utilizing an aerosol deposition method. J. micromech. Microeng. 2013, 23, 23. [Google Scholar] [CrossRef]
- Liu, H.; Lee, C.; Kobayashi, T.; Tay, C.J.; Quan, C. A new S-shaped MEMS PZT cantilever for energy harvesting from low frequency vibrations below 30 Hz. Microsyst. Technol. 2012, 18, 497–506. [Google Scholar] [CrossRef]
- Jiang, L.; Yang, Y.; Chen, R.; Lu, G.; Li, R.; Li, D.; Humayun, M.S.; Shung, K.K.; Zhu, J.; Chen, Y.; et al. Flexible piezoelectric ultrasonic energy harvester array for bio-implantable wireless generator. Nano Energy 2019, 56, 216–224. [Google Scholar] [CrossRef] [PubMed]
- Beeby, S.P.; Tudor, M.J.; White, N.M. Energy harvesting vibration sources for microsystems applications. Meas. Sci. Technol. 2006, 17, R175–R195. [Google Scholar] [CrossRef]
- Roundy, S.; Wright, P.K.; Rabaey, J. A study of low level vibrations as a power source for wireless sensor nodes. Comput. Commun. 2003, 26, 1131–1144. [Google Scholar] [CrossRef]
- Ruffo, R.; Hong, S.S.; Chan, C.K.; Huggins, R.A.; Cui, Y. Impedance Analysis of Silicon Nanowire Lithium Ion Battery Anodes. J. Phys. Chem. C 2009, 113, 11390–11398. [Google Scholar] [CrossRef] [Green Version]
- Invernizzi, F.; Dulio, S.; Patrini, M.; Guizzetti, G.; Mustarelli, P. Energy harvesting from human motion: Materials and techniques. Chem. Soc. Rev. 2016, 45, 5455–5473. [Google Scholar] [CrossRef]
- Gardonio, P.; Zilletti, M. Vibration energy harvesting from an array of flexible stalks exposed to airflow: A theoretical study. Smart Mater. Struct. 2016, 25, 35014. [Google Scholar] [CrossRef]
- Roundy, S. On the Effectiveness of Vibration-based Energy Harvesting. J. Intell. Mater. Syst. Struct. 2005, 16, 809–823. [Google Scholar] [CrossRef]
- Wang, P.; Dai, X.; Fang, D.-M.; Zhao, X.-L. Design, fabrication and performance of a new vibration-based electromagnetic micro power generator. Microelectron. J. 2007, 38, 1175–1180. [Google Scholar] [CrossRef]
- Altena, G.; Renaud, M.; Elfrink, R.; Goedbloed, M.H.; De Nooijer, C.; Van Schaijk, R. Design improvements for an electret-based MEMS vibrational electrostatic energy harvester. J. Phys. Conf. Ser. 2013, 476, 012078. [Google Scholar] [CrossRef] [Green Version]
- Howells, C.A. Piezoelectric energy harvesting. Energy Convers. Manag. 2009, 50, 1847–1850. [Google Scholar] [CrossRef]
- Kim, S.; Clark, W.W.; Wang, Q.-M. Piezoelectric Energy Harvesting with a Clamped Circular Plate: Experimental Study. J. Intell. Mater. Syst. Struct. 2005, 16, 855–863. [Google Scholar] [CrossRef]
- Kim, H.S.; Kim, J.-H.; Kim, J. A review of piezoelectric energy harvesting based on vibration. Int. J. Precis. Eng. Manuf. 2011, 12, 1129–1141. [Google Scholar] [CrossRef]
- Toprak, A.; Tigli, O. Piezoelectric energy harvesting: State-of-the-art and challenges. Appl. Phys. Rev. 2014, 1, 031104. [Google Scholar] [CrossRef]
- Yang, Z.; Zhou, S.; Zu, J.; Inman, D. High-Performance Piezoelectric Energy Harvesters and Their Applications. Joule 2018, 2, 642–697. [Google Scholar] [CrossRef] [Green Version]
- Wu, J.; Shi, H.; Zhao, T.; Yu, Y.; Dong, S. High-Temperature BiScO3-PbTiO3Piezoelectric Vibration Energy Harvester. Adv. Funct. Mater. 2016, 26, 7186–7194. [Google Scholar] [CrossRef]
- Homayouni-Amlashi, A.; Mohand-Ousaid, A.; Rakotondrabe, M. Analytical Modelling and Optimization of a Piezoelectric Cantilever Energy Harvester with In-Span Attachment. Micromachines 2020, 11, 591. [Google Scholar] [CrossRef]
- Wang, W.; Yang, T.; Chen, X.; Yao, X. Vibration energy harvesting using a piezoelectric circular diaphragm array. IEEE Trans. Ultrason. Ferroelectr. Freq. Control. 2012, 59, 2022–2026. [Google Scholar] [CrossRef]
- Tian, W.; Ling, Z.; Yu, W.; Shi, J. A Review of MEMS Scale Piezoelectric Energy Harvester. Appl. Sci. 2018, 8, 645. [Google Scholar] [CrossRef] [Green Version]
- Qi, L. Modeling of functionally graded circular energy harvesters due to flexoelectricity. Appl. Math. Model. 2019, 76, 578–590. [Google Scholar] [CrossRef]
- Xiao, Z.; Yang, T.Q.; Dong, Y.; Wang, X.C. Energy harvester array using piezoelectric circular diaphragm for broadband vibration. Appl. Phys. Lett. 2014, 104, 223904. [Google Scholar] [CrossRef]
- Yuan, T.-C.; Yang, J.; Chen, L.-Q. Nonlinear dynamics of a circular piezoelectric plate for vibratory energy harvesting. Commun. Nonlinear Sci. Numer. Simul. 2018, 59, 651–656. [Google Scholar] [CrossRef]
- Hillenbrand, J.; Hillenbrand, J.; Sessler, G.M.; Bös, J.; Melz, T. Vibration-based energy harvesting with stacked piezoelectrets. Appl. Phys. Lett. 2014, 104, 172901. [Google Scholar] [CrossRef]
- Dong, Y.; Yang, T.; Xiao, Z.; Liu, Y.; Wang, X. Performance enhancement of PZT material for circular diaphragm energy harvester. J. Mater. Sci. Mater. Electron. 2015, 26, 7921–7926. [Google Scholar] [CrossRef]
- Yang, Y.; Wang, S.; Stein, P.; Xu, B.-X.; Yang, T. Vibration-based energy harvesting with a clamped piezoelectric circular diaphragm: Analysis and identification of optimal structural parameters. Smart Mater. Struct. 2017, 26, 045011. [Google Scholar] [CrossRef]
- Shu, F.; Yang, T.; Liu, Y. Enhancement of power output by a new stress-applied mode on circular piezoelectric energy harvester. AIP Adv. 2018, 8, 045102. [Google Scholar] [CrossRef] [Green Version]
- Han, Y.; Li, Y.; Yang, Y.; Li, M.; Yang, T. Improvement of uneven charge distribution on piezoelectric circular diaphragm with notched-substrate. AIP Adv. 2020, 10, 045330. [Google Scholar] [CrossRef] [Green Version]
- Yang, Y.; Li, Y.; Guo, Y.; Xu, B.-X.; Yang, T. Improved vibration-based energy harvesting by annular mass configuration of piezoelectric circular diaphragms. Smart Mater. Struct. 2018, 27, 035004. [Google Scholar] [CrossRef]
- Liu, Y.; Yang, T.; Shu, F. Optimization of energy harvesting based on the uniform deformation of piezoelectric ceramic. Funct. Mater. Lett. 2016, 9, 1650069. [Google Scholar] [CrossRef]
- Janphuang, P.; Lockhart, R.; Uffer, N.; Briand, D.; De Rooij, N.F. Vibrational piezoelectric energy harvesters based on thinned bulk PZT sheets fabricated at the wafer level. Sens. Actuators A Phys. 2014, 210, 1–9. [Google Scholar] [CrossRef]
- Singh, K.A.; Kumar, R.; Weber, R.J. A Broadband Bistable Piezoelectric Energy Harvester with Nonlinear High-Power Extraction. IEEE Trans. Power Electron. 2015, 30, 6763–6774. [Google Scholar] [CrossRef]
- Song, H.-C.; Kumar, P.; Maurya, D.; Kang, M.-G.; Reynolds, W.T.; Jeong, D.-Y.; Kang, C.-Y.; Priya, S. Ultra-Low Resonant Piezoelectric MEMS Energy Harvester with High Power Density. J. Microelectromech. Syst. 2017, 26, 1226–1234. [Google Scholar] [CrossRef]
- Kim, M.; Hoegen, M.; Dugundji, J.; Wardle, B.L. Modeling and experimental verification of proof mass effects on vibration energy harvester performance. Smart Mater. Struct. 2010, 19, 045023. [Google Scholar] [CrossRef]
- Zou, H.-X.; Zhang, W.-M.; Li, W.-B.; Hu, K.-M.; Wei, K.-X.; Peng, Z.; Meng, G. A broadband compressive-mode vibration energy harvester enhanced by magnetic force intervention approach. Appl. Phys. Lett. 2017, 110, 163904. [Google Scholar] [CrossRef]
- Tian, Y.; Li, G.; Yi, Z.; Liu, J.; Yang, B. A low-frequency MEMS piezoelectric energy harvester with a rectangular hole based on bulk PZT film. J. Phys. Chem. Solids 2018, 117, 21–27. [Google Scholar] [CrossRef]
Part | Parameter 1 | Parameter 2 |
---|---|---|
PZT-5H | Diameter (d1)/25 mm | Thickness/0.1 mm |
Brass substrate | Diameter (d3)/41 mm | Thickness/0.1 mm |
Proof mass | Clamping diameter (d2)/38 mm | Weight/10 g |
Reference | Material/Configuration | Acceleration (g = 9.8 m/s2) | Frequency (Hz) | Output Power (Peak Value) | Power Density (mW/cm3) | Normalized Power Density (μW·g−2·Hz−1cm−3) |
---|---|---|---|---|---|---|
Janphuang et al. [32] 2014 | Thinned bulk PZT | 1 g | 96 | 82.4 μW | 1.73 | 17.95 |
Singh et al. [33] 2015 | PZT with SSHI circuit | 4.6 g | 90 | 385 μW | 3.27 | 1.72 |
Song et al. [34] 2017 | PZT with spiral shape | 0.25 g | 68 | 0.023 μW | 0.21 | 49.17 |
Kim et al. [35] 2010 | Bulk PZT | 0.255 g | 109.5 | 0.53 mW | 0.57 | 80.05 |
Zou et al. [36] 2017 | PZT with magnet | 0.4 g | 9.9 | 194 μW | 0.485 | 303.12 |
Tang et al. [37] 2018 | Thinned bulk PZT | 1.5 g | 34 | 226.6 μW | 1.71 | 22.22 |
This work | Bulk PZT | 1 g | 180 | 8.34 mW | 5.73 | 31.85 |
Publisher’s Note: MDPI stays neutral with regard to jurisdictional claims in published maps and institutional affiliations. |
© 2020 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (http://creativecommons.org/licenses/by/4.0/).
Share and Cite
Xu, C.; Li, Y.; Yang, T. Optimization of Non-Uniform Deformation on Piezoelectric Circular Diaphragm Energy Harvester with a Ring-Shaped Ceramic Disk. Micromachines 2020, 11, 963. https://doi.org/10.3390/mi11110963
Xu C, Li Y, Yang T. Optimization of Non-Uniform Deformation on Piezoelectric Circular Diaphragm Energy Harvester with a Ring-Shaped Ceramic Disk. Micromachines. 2020; 11(11):963. https://doi.org/10.3390/mi11110963
Chicago/Turabian StyleXu, Chaoqun, Yuanbo Li, and Tongqing Yang. 2020. "Optimization of Non-Uniform Deformation on Piezoelectric Circular Diaphragm Energy Harvester with a Ring-Shaped Ceramic Disk" Micromachines 11, no. 11: 963. https://doi.org/10.3390/mi11110963