Next Article in Journal
A Low Noise CMOS Readout Based on a Polymer-Coated SAW Array for Miniature Electronic Nose
Next Article in Special Issue
A 3D Optical Surface Profilometer Using a Dual-Frequency Liquid Crystal-Based Dynamic Fringe Pattern Generator
Previous Article in Journal
Sparse Reconstruction for Micro Defect Detection in Acoustic Micro Imaging
Previous Article in Special Issue
Robust Depth Image Acquisition Using Modulated Pattern Projection and Probabilistic Graphical Models
Open AccessArticle

Geometric Calibration and Validation of Kompsat-3A AEISS-A Camera

Korea Aerospace Research Institute, Daejeon 34133, Korea
Department of Civil Engineering, Chonnam National University, Gwangju 61186, Korea
Department of Civil Engineering, Seoul National University of Science and Technology, Seoul 01811, Korea
Author to whom correspondence should be addressed.
Academic Editor: Gonzalo Pajares Martinsanz
Sensors 2016, 16(10), 1776;
Received: 26 September 2016 / Revised: 19 October 2016 / Accepted: 20 October 2016 / Published: 24 October 2016
(This article belongs to the Special Issue Imaging: Sensors and Technologies)
Kompsat-3A, which was launched on 25 March 2015, is a sister spacecraft of the Kompsat-3 developed by the Korea Aerospace Research Institute (KARI). Kompsat-3A’s AEISS-A (Advanced Electronic Image Scanning System-A) camera is similar to Kompsat-3’s AEISS but it was designed to provide PAN (Panchromatic) resolution of 0.55 m, MS (multispectral) resolution of 2.20 m, and TIR (thermal infrared) at 5.5 m resolution. In this paper we present the geometric calibration and validation work of Kompsat-3A that was completed last year. A set of images over the test sites was taken for two months and was utilized for the work. The workflow includes the boresight calibration, CCDs (charge-coupled devices) alignment and focal length determination, the merge of two CCD lines, and the band-to-band registration. Then, the positional accuracies without any GCPs (ground control points) were validated for hundreds of test sites across the world using various image acquisition modes. In addition, we checked the planimetric accuracy by bundle adjustments with GCPs. View Full-Text
Keywords: Kompsat-3A; AEISS-A; calibration; validation Kompsat-3A; AEISS-A; calibration; validation
Show Figures

Figure 1

MDPI and ACS Style

Seo, D.; Oh, J.; Lee, C.; Lee, D.; Choi, H. Geometric Calibration and Validation of Kompsat-3A AEISS-A Camera. Sensors 2016, 16, 1776.

Show more citation formats Show less citations formats
Note that from the first issue of 2016, MDPI journals use article numbers instead of page numbers. See further details here.

Article Access Map by Country/Region

Back to TopTop