Next Article in Journal
Interplay between Selenium, Selenoproteins and HIV-1 Replication in Human CD4 T-Lymphocytes
Next Article in Special Issue
Development and Characterization of Highly Stable Silver NanoParticles as Novel Potential Antimicrobial Agents for Wound Healing Hydrogels
Previous Article in Journal
Metabolites and Genes behind Cardiac Metabolic Remodeling in Mice with Type 1 Diabetes Mellitus
Previous Article in Special Issue
Natural Compound Resveratrol Attenuates TNF-Alpha-Induced Vascular Dysfunction in Mice and Human Endothelial Cells: The Involvement of the NF-κB Signaling Pathway
 
 
Article
Peer-Review Record

Amphiphilic Pentablock Copolymers Prepared from Pluronic and ε-Caprolactone by Enzymatic Ring Opening Polymerization

Int. J. Mol. Sci. 2022, 23(3), 1390; https://doi.org/10.3390/ijms23031390
by Ahmed Abd El-Fattah 1,2,3,*, Elizabeth Grillo Fernandes 1,4,*, Federica Chiellini 1 and Emo Chiellini 1
Reviewer 1: Anonymous
Reviewer 2: Anonymous
Int. J. Mol. Sci. 2022, 23(3), 1390; https://doi.org/10.3390/ijms23031390
Submission received: 31 December 2021 / Revised: 18 January 2022 / Accepted: 21 January 2022 / Published: 26 January 2022

Round 1

Reviewer 1 Report

Please see the attached file.

Comments for author File: Comments.pdf

Author Response

"Please see the attachment."

Author Response File: Author Response.pdf

Reviewer 2 Report

The paper submitted by El-Fattah et al. deals with the synthesis and characterization of two series of copolymers based on Pluronic and PCL. These copolymers were obtained in the absence of any toxic catalysts which make them suitable for biomedical applications.

The manuscript is clear, well written and and conclusions are supported by the results. However, some minor corrections are needed before publication:

  1. in the abstract section, please use do not use abbreviations without providing firstly the full name
  2. actually the term "polydispersity index PDI" is no longer accepted and should be replace with "Dispersity Đ" 
  3. in the section about the solid state characterization, please use the following reference: https://doi.org/10.1016/j.polymer.2011.05.017
  4. in fig 9, please add the data for positive and negative control.

Author Response

"Please see the attachment."

Author Response File: Author Response.pdf

Back to TopTop