Search Results (6)

Contaminants of emerging concern, such as pharmaceuticals (PhACs), are continuously introduced into agro-ecosystems through irrigation with treated wastewater (TWW). While this practice is increasingly common in drought regions, only limited information is available on the fate of PhACs within the soil–plant system. For this purpose, a two-year study was conducted by irrigating artichokes, non-inoculated and inoculated with different arbuscular mycorrhizal fungi, with water containing PhACs at different concentrations. The experiment, conducted in both open field and pot conditions, aimed to evaluate their potential accumulation in the soil and plant tissues. Results showed that PhACs concentrations varied according to the physicochemical properties of the compounds and the duration of irrigation. The study revealed minimal accumulation of contaminants in the soil and non-edible plant parts. This was observed only at the end of the second growing cycle, when the plants were irrigated with TWW containing trace PhAC levels. In contrast, during both pot cultivation cycles, PhACs accumulated in the soil were translocated into plant organs when irrigated with water enriched to 200 μg L⁻¹ with eight PhACs. At the end of the trial, climbazole had the highest concentration in soil, while carbamazepine and fluconazole showed greater accumulation across all plant organs compared to other PhACs. In both trials, plants inoculated with Septoglomus viscosum absorbed less PhACs compared to those inoculated with Rhizophagus irregularis + Funneliformis mosseae. These results suggest that, while the long-term use of TWW containing PhACs may improve artichoke yield, it could present different degrees of risk to both environmental and human health, depending on the concentration levels of contaminants. Full article

Technological advancement in recent decades has allowed for crop cultivation in soilless controlled environments, known as hydroponics, and this is being employed in an increasing number of factories worldwide. With continued local and regional disruptions in the supply chain to provide mineral fertilizers, new pathways to generate nutrient solutions are being developed. One potential approach is the recovery of nutrients from organic waste and wastewater using bioponics. Bioponics refers to the biological mineralization of organic residues through processes such as anaerobic and aerobic digestion and the use of such organically produced nutrient solutions in hydroponic systems. However, without disinfection of the nutrient solution, the high microbial loads increase the risk of pathogens affecting plant and consumer health. In this work, electrochemical hydrogen peroxide (H₂O₂) demonstrated success in reducing microbial loads. Different scenarios of application were considered: (1) variation in the H₂O₂ concentration in the nutrient solution by dosing H₂O₂ from ex situ electrochemical production, (2) variation in the dosing time-dependent reaction between the nutrient solution and H₂O₂ produced ex situ, and (3) the in situ production of H₂O₂ of the organic nutrient solution. The highest tested H₂O₂ concentration of 200 mg L⁻¹ showed a microbial load reduction of bacteria at 93.3% and of fungi at 81.2%. However, the in situ production showed the highest reduction rate for bacteria and fungi in bioponic nutrient solutions, where longer reaction times also impact microbial concentrations in situ. Final microbial reductions of 97.8% for bacteria and of 99.1% for fungi were determined after a H₂O₂ production time of 60 min. Overall, our results show that electrochemical H₂O₂ production can be used to disinfect bioponic nutrient solutions, and the production cell can be implemented in bioponic systems in situ. Full article

High salinity, nutrient imbalance, and pathogens are some of the challenges of closed soilless cultivation systems, e.g., those combining hydroponics (HP) with aquaculture effluents (AE). Plant growth-promoting microorganisms (PGPM) can support plants to cope with stressing agents. To address these topics, lettuces were grown in soilless systems (20 boxes) at an electrical conductivity of around 4.2–5 mS/cm, following a full factorial design with two nutrient sources and five bacterial treatments. The nutrient sources were either organic (AE) or inorganic (HP); the treatments were either commercial PGPM or sludges of an aquaculture farm or of an urban wastewater treatment plant. Finally, half the plants were exposed to pathogen Pythium sp. After 61 days of culture, most of the differences between HP- and AE-plants could be attributed to the composition of the nutrient solutions. Nutrient imbalances, salinity, and the pathogen exposition did not cause severe damage, except for tip burn. Fresh weight was significantly higher in HP (177.8 g) than in AE (107.0 g), while the chlorophyll and flavonoid levels tended to be higher in AE. The leaf sodium and chlorine concentrations were higher than the values found in similar studies; however, AE plants contained a lower content of sodium and chlorine (35.0 and 21.5 mg/g dry weight) than the HP ones (44.6 and 28.6 mg/g dry weight). Many macro- and micronutrients in the AE-grown plants tended to be higher when the commercial PGPM or the sludges were administered, supporting the idea that those treatments contain a flora that helps to extract nutrients from organic sources. The study demonstrated that lettuce can be successfully cultured at relatively high salt concentration. To further investigate beneficial services such as nutrient extraction, salinity mitigation, and pathogen protection, we suggest administering bacterial communities of known composition, or single microbial strains. The study also showed that PGPM can be found in sludges of different origins; isolating beneficial strains from sludge would additionally transform its management from a burdensome cost to a source of beneficial services. Full article

Soilless tomato cultivation wastewater, with typically low COD, high concentrations of phosphorus, and oxidized forms of nitrogen, may be effectively treated in a rotating electrochemical disk contactor (RECDC) and in a bioelectrochemical reactor (BER), such as a rotating electrobiological disk contactor (REBDC). The aim of this study was to determine the technological parameters of both reactors, i.e., electric current density (J) and hydraulic retention time (HRT), depending on the effluent quality requirements. The study was conducted with four one-stage RECDCs and with four one-stage REBDCs, at four hydraulic retention times, i.e., 4, 8, 12, and 24 h, and electric current densities of 0.63, 1.25, 2.50, 5.00, and 10.00 A/m². It was demonstrated that soilless tomato cultivation wastewater could be effectively treated in electrochemical and electrobiological disk contactors, and then discharged to sewage system facilities. In a RECDC, the highest denitrification (53.4%) and dephosphatation (99.8%) performance was achieved at J = 10.0 A/m² and HRT = 24 h. If the effluents are to be discharged to natural reservoirs, their effective treatment is only feasible in a REBDC. The bioelectrochemical disk contactor ensured over 90% dephosphatation effectiveness. At HRT = 24 h and all electric current densities studied, the concentrations of pollutants in the effluent met requirements set for industrial wastewater discharged into natural waters and the ground. By applying J = 2.5 A/m² and HRT = 24 h in the REBDC, it was possible to achieve a phosphorus concentration below 3.0 mg P/L and concentrations of ammonia nitrogen and nitrites lower than the permissible levels for treated industrial wastewater introduced to waters and to the ground. Given the nitrate concentration (exceeding 30 mg N/L), an external carbon source is recommended to aid a treatment process that uses a technological system with a REBDC. Technological schemes were proposed for wastewater treatment plants (WWTPs) with a RECDC and a REBDC, for discharging treated wastewater to natural waters, the ground, and sewage systems. Full article

Greenhouse horticulture is one of the most intensive agricultural systems, with the advantages of environmental parameter control (temperature, light, etc.), higher efficiency of resource utilization (water, fertilizers, etc.) and the use of advanced technologies (hydroponics, automation, etc.) for higher productivity, earliness, stability of production and better quality. On the other hand, climate change and the application of high inputs without suitable management could have negative impacts on the expansion of the greenhouse horticulture sector. This special issue gathers twelve papers: three reviews and nine of original research. There is one review that focuses on irrigation of greenhouse crops, while a second surveys the effects of biochar on container substrate properties and plant growth. A third review examines the impact of light quality on plant–microbe interactions, especially non-phototrophic organisms. The research papers report both the use of new technologies as well as advanced cultivation practices. In particular, new technologies are presented such as dye-sensitized solar cells for the glass cover of a greenhouse, automation for water and nitrogen deficit stress detection in soilless tomato crops based on spectral indices, light-emitting diode (LED) lighting and gibberellic acid supplementation on potted ornamentals, the integration of brewery wastewater treatment through anaerobic digestion with substrate-based soilless agriculture, and application of diatomaceous earth as a silica supplement on potted ornamentals. Research studies about cultivation practices are presented comparing different systems (organic-conventional, aeroponic-nutrient film technique (NFT)-substrate culture), quantitative criteria for determining the quality of grafted seedlings, and of wild species as alternative crops for cultivation. Full article

The study was conducted in a one-stage rotating electrobiological disk contactor (REBDC) and a rotating electrochemical disk contactor (RECDC). Synthetic wastewater with characteristics similar to the wastewater from soil-less cultivation of tomatoes was used in the experiment. Current efficiency (CE) values, that express the denitrification performance of bio- and electrochemical reactors, were higher in the electrobiological contactor than in the electrochemical one. Combining biological processes with electrochemical processes in the electrobiological contactor resulted in almost 20% higher current efficiency in the contactor operated at a density of 0.63 A/m² and hydraulic retention time (HRT) = 4 h. The study showed that, in both the electrochemical and the electrobiological contactor, current density increase and hydraulic retention time extension increased electric power consumption (E) during phosphorus compounds removal and simultaneously lowered current efficiency. Full article