Search Results (7)

Background: The radius, a crucial bone in the human forearm, supports and facilitates complex movements like pronation and supination. Its anatomical landmarks, including Lister’s tubercle, provide vital attachment points for muscles, tendons, and ligaments involved in upper limb mobility. This study provides a detailed osteometric analysis of the dorsal radial tubercle of the radius, aiming to improve our understanding of its anatomy and clinical significance. Material and Methods: The study was conducted in the Department of Anatomy and Embryology, using 56 radius bones from cadavers. After applying inclusion and exclusion criteria, 46 bones remained in the study group. Results: The study found a significant positive correlation between the length of the radius and the width of the distal epiphysis. The distance from the suprastyloid crest to the dorsal radial tubercle (SC-DT) and the distal epiphysis width were strongly associated with the development of the distal radial epiphysis. The distance between the dorsal radial tubercle and the oblique ridge (OR-RI) and between the oblique ridge and the radial incisure (DT-OR) also showed a strong positive correlation with the distal epiphysis width. Conclusions: In conclusion, the osteometric study performed reveals significant correlations between the bony elements of distal radius epiphysis that can provide valuable information regarding anatomic variability and surgical treatment of distal radial epiphyseal fractures. Full article

Objectives: This systematic review addressed the following questions: what are the most recommended diagnostic criteria for pulley injuries in finger flexors among climbers? What is the best functional or classification clinical test for these injuries based on the available evidence? Materials and Methods: Following the PRISMA Statement checklist, a systematic literature review was conducted between August and September 2023, using a search on the PubMed database with a string of keywords and MeSH terms. The PEDro scale was used to analyze bias in the individual studies examined. Conclusions: Based on the exclusion criteria and research question, 14 articles with heterogeneous study designs were selected. Studies involving diagnosis through clinical examination or instrumental tests were analyzed. The data obtained provide an overview of different diagnostic and classification criteria for the injury under consideration. Ultrasounds remain the gold standard in diagnosing finger pulley injuries. The distance between the tendon and bone is the most used diagnostic criterion, with a distance greater than 2 mm corresponding to an A2 or A4 pulley injury. The clinical sign of bowstringing coincides with a multiple pulley injury involving A2, A3, and A4. Clinical signs, ultrasounds, and grip strength should be evaluated for a comprehensive diagnosis. A grip deficit of 41.4% corresponds to a pulley injury. Full article

Background/Objectives: Rock climbing is becoming more popular, leading to an increased focus on diagnosing and treating related injuries. Finger pulley and flexor tendon injuries are common among climbers, with the A2 pulley being the most frequently affected. High-resolution ultrasound (US) is the preferred method for detecting pulley injuries. This study aimed to determine the reliability and validity of US in identifying anatomical landmarks for diagnosing A2 pulley ruptures. Methods: This study was cross-sectional, involving 36 fingers from 4 cadaver arms. A Canon Aplio i800 US machine was used to measure two anatomical landmarks: the midpoint of the proximal phalanx and the distal edge of the A2 pulley. For the first anatomical landmark, the length of the proximal phalanx (PP distance), and for the second landmark, the distance between the distal edges of the proximal phalanx and the A2 pulley (“A” distance), were measured. Measurements were performed by two sonographers and compared to a digital caliper measurement taken post-cadaver dissection. Observers were blinded during measurements to ensure unbiased results. Results: Overall PP distance measured by US (O1: 37.5 ± 5.3 mm, O2: 37.8 ± 5.4 mm) tended to be shorter than caliper measurements (O3: 39.5 ± 5.5 mm). The differences between sonographers were minimal, but larger when compared to caliper measurements. High reliability for PP distance measurement was observed, especially between sonographers, with an ICC average of 0.99 (0.98, 1.00). However, reliability was lower for the “A” distance, with significant differences between US and caliper measurements. Regarding validity, US measurements were valid when compared to caliper measurements for PP distance, but not as reliable for the “A” due to wider confidence intervals. While US can substitute caliper measurements for PP distance (LR, Y:O2, X:O3, −0.70 (−3.28–1.38), 0.98 (0.93 ± 1.04)), its validity for “A” distance is lower (LR, Y:O2, X:O3, −2.37 (−13.53–4.83), 1.02 (0.62–1.75)). Conclusions: US is a reliable and valid tool in identifying anatomical landmarks for diagnosing A2 pulley ruptures, particularly for detecting the midpoint of the proximal phalanx. This is important to differentiate between complete and partial A2 pulley tears. However, the measurement of the “A” distance requires further refinement. These findings support efforts to standardize US examination protocols and promote consensus in diagnostic methodology, though further research is needed to address the remaining challenges. Full article

A protocol is proposed to acquire a tomographic ultrasound (US) scan of the musculoskeletal (MSK) anatomy in the rotator cuff region. Current clinical US imaging techniques are hindered by occlusions and a narrow field of view and require expert acquisition and interpretation. There is limited literature on 3D US image registration of the shoulder or volumetric reconstruction of the full shoulder complex. We believe that a clinically accurate US volume reconstruction of the entire shoulder can aid in pre-operative surgical planning and reduce the complexity of US interpretation. The protocol was used in generating data for deep learning model training to automatically register US mosaics in real-time. An in vivo 3D US tomographic reconstruction of the entire rotator cuff region was produced by registering 53 sequential 3D US volumes acquired by an MSK sonographer. Anatomical surface thicknesses and distances in the US mosaic were compared to their corresponding MRI measurements as the ground truth. The humeral head surface was marginally thicker in the reconstructed US mosaic than its original thickness observed in a single US volume by 0.65 mm. The humeral head diameter and acromiohumeral distance (ACHD) matched with their measured MRI distances with a reconstruction error of 0 mm and 1.2 mm, respectively. Furthermore, the demonstration of 20 relevant MSK structures was independently graded between 1 and 5 by two sonographers, with higher grades indicating poorer demonstration. The average demonstration grade for each anatomy was as follows: bones = 2, muscles = 3, tendons = 3, ligaments = 4–5 and labrum = 4–5. There was a substantial agreement between sonographers (Cohen’s Weighted kappa of 0.71) on the demonstration of the structures, and they both independently deemed the mosaic clinically acceptable for the visualisation of the bony anatomy. Ligaments and the labrum were poorly observed due to anatomy size, location and inaccessibility in a static scan, and artefact build-up from the registration and compounding approaches. Full article

The ability of finger flexors to generate force has been studied in relation to climbing performance. However, not much attention has been paid to the decrease in finger grip force in relation to annular pulley injuries. The purpose of the present study was to determine if an injured annular pulley implies a finger flexor force decrease, as well as its relation to clinical and sonographic changes. We performed an observational study in 39 rock climbers with A2 or A4 pulley injuries to the 3rd or 4th fingers. The variables considered were pain upon palpation, ultrasound tendon–bone distance, and finger grip strength decrease. Three rock climbing grip types were considered: the one finger crimp, open crimp, and close crimp. Injured rock climbers presented a decrease in finger grip strength compared to non-injured controls when performing a one finger crimp (p < 0.001). There exists a significant correlation between a tendon–bone distance at the level of the injured pulley and a decreased finger grip strength measured by performing a one finger crimp (p = 0.006). A decrease in finger grip strength could be considered in the diagnostic and follow-up process of A2 and A4 pulley injuries to the 3rd and 4th fingers. Full article

The poor and slow healing capacity of tendons requires novel strategies to speed up the tendon repair process. Hence, new and promising developments in tendon tissue engineering have become increasingly relevant. Previously, we have established a tendon progenitor cell line via ectopic expression of the tendon-related basic helix-loop-helix (bHLH) transcription factor Scleraxis (Scx) in human bone marrow mesenchymal stem cells (hMSC-Scx). The aim of this study was to directly compare the characteristics of hMSC-Scx cells to that of primary human tendon stem/progenitors cells (hTSPCs) via assessment of self-renewal and multipotency, gene marker expression profiling, in vitro wound healing assay and three-dimensional cell sheet formation. As expected, hTSPCs were more naive than hMSC-Scx cells because of higher clonogenicity, trilineage differentiation potential, and expression of stem cell markers, as well as higher mRNA levels of several gene factors associated with early tendon development. Interestingly, with regards to wound healing, both cell types demonstrate a comparable speed of scratch closure, as well as migratory velocity and distance in various migration experiments. In the three-dimensional cell sheet model, hMSC-Scx cells and hTSPCs form compact tendinous sheets as histological staining, and transmission electron microscopy shows spindle-shaped cells and collagen type I fibrils with similar average diameter size and distribution. Taken together, hTSPCs exceed hMSC-Scx cells in several characteristics, namely clonogenicity, multipotentiality, gene expression profile and rates of tendon-like sheet formation, whilst in three-dimensional cell sheets, both cell types have comparable in vitro healing potential and collagenous composition of their three-dimensional cell sheets, making both cell types a suitable cell source for tendon tissue engineering and healing. Full article

Iatrogenic injuries to cranial nerves, half of which affect the hypoglossal nerve, occur in up to 20% of surgical procedures involving the neck. The risk of injury could be minimized by in-depth knowledge of its positional and relational anatomy. Forty-one hypoglossal nerves were dissected from cadaveric specimens and positions described in relation to the internal carotid artery (ICA), external carotid artery (ECA), carotid bifurcation, mandible, hyoid bone, mastoid process, and the digastric tendon. The distance of the nerve from where it crossed the ICA and ECA to the carotid bifurcation was 29.93 (±5.99) mm and 15.19 (±6.68) mm, respectively. The point where it crossed the ICA was 12.24 (±3.71) mm superior to the greater horn of hyoid, 17.16 (±4.40) mm inferior to the angle of the mandible, and 39.08 (±5.69) mm from tip of the mastoid. The hypoglossal nerve loop was inferior to the digastric tendon in 73% of the cases. The hypoglossal nerves formed high loops in this study population. Caution should be exercised during surgical procedures in the neck. The study also revealed that the mastoid process is a reliable fixed landmark to locate the hypoglossal nerve. Full article