Search Results (2)

Nanofibrous membranes have gained interest for their small pore size, light weight, and excellent filtration. When produced from high-performance polymers, nanofibrous membranes also benefit from excellent mechanical properties, thermal resistance, and chemical resistance. Electrospinning is a common method of producing high-performance nanofibres. However, there are still major challenges with the dissolution and electrospinning of these polymers, as well as in the performance of the resulting nanofibres, which is often less than what would be expected from a conventional high-performance fibre. This review assesses the state of progress in the electrospinning of five high-performance fibres: meta-aramid (m-aramid), para-aramid (p-aramid), polyamide-imide (PAI), polybenzoxazole (PBO), and polybenzimidazole (PBI). Polymers that can be readily dissolved in organic solvents, such as m-aramid, PAI, and PBI, have been more widely researched for electrospinning compared to those that can only be spun from precursors or dissolved in non-volatile solvents. Major focuses within the literature include optimizing the electrospinning process and improving the mechanical performance of the nanofibres. This review demonstrates a clear need for more standardized characterization methods and consideration for the longevity of the nanofibrous membranes. Future research should also focus on scale-up methods of electrospinning so that the benefits of nanofibres made from high-performance polymers can be leveraged by the industry. Full article

The effects of the yarn composition system inside 3D woven high-performance textiles are not well investigated and understood against their final ballistic impact behaviour. The current study aims to examine the ballistic impact performances of armour panels made of different 3D woven fabric variants through postmortem observations. Four high-performance five-layer 3D woven fabric variants were engineered based on their different warp yarn compositions but similar area density. A 50 × 50 cm² armour system of each variant, which comprises eight nonbonded but aligned panels, namely, 3D-40-8/0 (or 8/0), 3D-40-8/4 (or 8/4), 3D-40-8/8 (or 8/8) and 3D-40-4/8 (or 4/8), were prepared and moulded to resemble female frontal morphology. The armour systems were then tested with nonperforation ballistic impacts according to the National Institute of Justice (NIJ) 0101.06 standard Level-IIIA. Two high-speed cameras were used to capture the event throughout the test. Nondestructive investigation (NDI) using optical microscopic and stereoscopic 3D digital images were employed for the analysis. The armour panels made of the 8/0 and 4/8 fabric variants were perforated, whereas the armour made of the 8/8 and 8/4 fabric variants showed no perforation. Besides, the armour made of the 8/4 fabric variant revealed higher local and global surface displacements than the other armours. The current research findings are useful for further engineering of 3D woven fabric for seamless women’s impact protective clothing. Full article