Search Results (2)

“Dark-cutting” meat in beef carcasses can result from conditions such as long-term stress and depleted glycogen stores, but some aspects of the physiological mechanisms that cause dark-cutting phenotypes remain poorly understood. Certain responses to stress factors in fully developed tissues are known to be regulated by specific microRNAs. We investigated microRNA expression in Longissimus lumborum biopsies from carcasses derived from a contemporary group of 78 steers from which a high incidence of dark-cutting meat occurred. Our objective was to identify any potential microRNA signatures that reflect the impact of environmental factors and stresses on genetic signaling networks and result in dark-cutting beef (also known as dark, firm, and dry, or DFD) in some animals. MicroRNA expression was quantified by Illumina NextSeq small RNA sequencing. When RNA extracts from DFD muscle biopsy samples were compared with normal, non-DFD (NON) samples, 29 differentially expressed microRNAs were identified in which expression was at least 20% different in the DFD samples (DFD/NON fold ratio ≤0.8 or ≥1.2). When correction for multiple testing was applied, a single microRNA bta-miR-2422 was identified at a false discovery probability (FDR) of 5.4%. If FDR was relaxed to 30%, additional microRNAs were differentially expressed (bta-miR-10174-5p, bta-miR-1260b, bta-miR-144, bta-miR-142-5p, bta-miR-2285at, bta-miR-2285e, bta-miR-3613a). These microRNAs may play a role in regulating aspects of stress responses that ultimately result in dark-cutting beef carcasses. Full article

Cobalt-cemented carbide micro-end mills were coated with diamond grown by chemical vapor deposition (CVD), with the purpose of micro-machining cemented carbides. The diamond coatings were designed with a multilayer architecture, alternating between sub-microcrystalline and nanocrystalline diamond layers. The structure of the coatings was studied by transmission electron microscopy. High adhesion to the chemically pre-treated WC-7Co tool substrates was observed by Rockwell C indentation, with the diamond coatings withstanding a critical load of 1250 N. The coated tools were tested for micro-end-milling of WC-15Co under air-cooling conditions, being able to cut more than 6500 m over a period of 120 min, after which a flank wear of 47.8 μm was attained. The machining performance and wear behavior of the micro-cutters was studied by scanning electron microscopy and energy-dispersive X-ray spectroscopy. Crystallographic analysis through cross-sectional selected area electron diffraction patterns, along with characterization in dark-field and HRTEM modes, provided a possible correlation between interfacial stress relaxation and wear properties of the coatings. Overall, this work demonstrates that high adhesion of diamond coatings can be achieved by proper combination of chemical attack and coating architecture. By preventing catastrophic delamination, multilayer CVD diamond coatings are central towards the enhancement of the wear properties and mechanical robustness of carbide tools used for micro-machining of ultra-hard materials. Full article