Search Results (3)

Nanomaterial-based catalytic conversion of hazardous organic pollutants into benign substances is one of the green methods employed for wastewater treatment. This study demonstrates the fabrication of (rGO-ZnO)/CuO nanocomposites (NCs) via a microwave (MW)-assisted method for (photo)catalytic application. The crystal structure, optical, morphological, and electrochemical characteristics were examined using X-ray diffraction (XRD), spectroscopic, microscopic, and electrochemical techniques. The analysis indicated that rod-like (rGO-ZnO)/CuO NCs having a nanoscale diameter with enhanced light absorption and well-matched band positions between rGO-ZnO and CuO were formed. Furthermore, the catalytic reduction of 4-nitrophenol (4-NP) and photocatalytic degradation of methylene blue (MB) tests showed remarkable results with rate constants of 0.468 min⁻¹ for 4-NP reduction within 8 min and 0.02213 min⁻¹ for MB degradation within 105 min. Thus, the artful decoration of ZnO nanorods (NRs) with CuO into the (rGO-ZnO)/CuO NCs interface is an effective strategy for fabricating highly efficient photocatalysts. Full article

In this research, ZnO/GO nanocomposites were successfully synthesized by a simple hydrothermal method using graphene oxide (GO) and zinc acetate dihydrate (Zn(CH₃COO)₂.2H₂O) as the reactants. The effect of the hydrothermal reaction time on the structure and optical property of the ZnO/GO was systematically investigated. The structure, morphology and chemical composition of the samples were measured by X-ray diffraction (XRD), field emission scanning electron microscopy (FESEM), transmission electron microscopy (TEM), energy-dispersive X-ray spectroscopy (EDS) and Raman and Fourier transform infrared (FTIR) spectroscopy, while the optical properties were measured using photoluminescence spectroscopy. The synthesized products consisted of large quantities of one-dimensional (1D) ZnO nanorods (NRs), which were dispersed uniformly on the GO surface. The XRD and Raman results reveal that the ZnO NRs in the fabricated samples had a hexagonal wurtzite structure with high crystalline quality. The FESEM and TEM images reveal that ZnO NRs with an average diameter in the range of ~85–270 nm and length in the range of ~0.3–6 μm were covered with GO sheets. Additionally, it was found that the crystallographic orientation of ZnO NRs was dependent not only on the hydrothermal reaction time but also on the presence of GO in the nanocomposites. However, the addition of GO did not affect the stoichiometric ratio and the crystal structure of ZnO NRs. The room-temperature PL results indicated that, compared to those of pure ZnO, the luminescence of the GO/ZnO nanocomposites was suppressed and shifted towards a higher wavelength (red shift), which was attributed to the incorporation of ZnO NRs within the GO matrix and the formation of a C-O-Zn chemical bond in the nanocomposites. The hydrothermal technique is considered one of the best routes due to its low cost, high growth rates, low-temperature synthesis, controllable crystallographic orientation, particle size, as well as morphology. Full article

In this work, the effects of graphene oxide (GO) concentrations (1.5 wt.%, 2.5 wt.%, and 5 wt.%) on the structural, morphological, optical, and luminescence properties of zinc oxide nanorods (ZnO NRs)/GO nanocomposites, synthesized by a facile hydrothermal process, were investigated. X-ray diffraction (XRD) patterns of NRs revealed the hexagonal wurtzite structure for all composites with an average coherence length of about 40–60 nm. A scanning electron microscopy (SEM) study confirmed the presence of transparent and wrinkled, dense GO nanosheets among flower-like ZnO nanorods, depending on the GO amounts used in preparation. Raman spectroscopy, Fourier transform infrared spectroscopy (FTIR), ultraviolet–visible (UV–Vis) absorption spectroscopy, and photoluminescence (PL) measurements revealed the impact of GO concentration on the optical and luminescence properties of ZnO NRs/GO nanocomposites. The energy band gap of the ZnO nanorods was independent of GO concentration. Photoluminescence spectra of nanocomposites showed a significant decrease in the intensities in the visible light range and red shifted suggesting a charge transfer process. The nanocomposites’ chromaticity coordinates for CIE 1931 color space were estimated to be (0.33, 0.34), close to pure white ones. The obtained results highlight the possibility of using these nanocomposites to achieve good performance and suitability for optoelectronic applications. Full article