Search Results (4)

Cancer and infectious diseases are major causes of global morbidity and mortality stressing the need to find novel drugs with promising dual anticancer and antimicrobial efficacy. Gold complexes have been studied for the past years due to their anticancer properties, with a few of them displaying antimicrobial properties, which support their pharmacological interest. Within this scope, we investigated six gold bisdithiolate complexes [Au (bdt)₂]⁻ (1), [Au (dcbdt)₂]⁻ (2), [Au (3-cbdt)₂]⁻ (3), [Au (4-cbdt)₂]⁻ (4), [Au (pdt)₂]⁻ (5) and [Au (dcdmp)₂]⁻ (6), and) against the ovarian cancer cell lines A2780 and A2780cisR, the Gram-positive bacteria Staphylococcus aureus Newman, the Gram-negative bacteria Escherichia coli ATCC25922 and Burkholderia contaminans IST408, and the pathogenic yeasts Candida glabrata CBS138 and Candida albicans SC5134. Complexes 2 and 6, with ligands containing aromatic pyrazine or phenyl rings, substituted with two cyanonitrile groups, showed after 24 h of incubation high anticancer activities against A2780 ovarian cancer cells (IC₅₀~5 µM), being also able to overcome cisplatin resistance in A2780cisR cells. Both complexes induced the formation of ROS, activated caspase-3/7, and induced necrosis (LDH release) in a dose-dependent way, in a greater extent in the case of 6. Among the bacterial and fungal strains tested, only complex 6 presented antimicrobial activity against S. aureus Newman, indicating that this complex is a potential novel anticancer and antibacterial agent. These results delve into the structure-activity relationship of the complexes, considering molecular alterations such as replacing a phenyl group for a pyrazine group, and the inclusion of one or two cyanonitrile appendage groups, and their effects on biological activity. Overall, both complexes were found to be promising leads for the development of future anticancer drugs against low sensitive or cisplatin resistant tumors. Full article

New iron and cobalt bis(dithiolene) complexes [M(3cbdt)₂] (3cbdt = 3-cyanobenzene-1,2-dithiolate) were prepared as tetraphenylphosphonium (Ph₄P⁺) salts for Fe in the monoanionic state and for Co in both the dianionic and monoanionic states: (Ph₄P)₂[Fe(III)(3cbdt)₂]₂ (1); (Ph₄P)₂[Co(III)(3cbdt)₂]₂ (2); (Ph₄P)₂[Co(II)(3cbdt)₂] (3). These compounds were characterized by single-crystal X-ray diffraction, cyclic voltammetry, EPR, and static magnetic susceptibility. Their properties are discussed in comparison with the corresponding complexes based on the isomer ligand 4-cyanobenzene-1,2-dithiolate (4cbdt) and 4,5-cyanobenzene-1,2-dithiolate (dcbdt), previously described by us. The Fe(III) and the Co(III) compounds (1 and 2) are isostructural, crystallizing in the triclinic $P\overline{1}$ space group, with cis [M(III)(3cbdt)₂] complexes dimerized in a trans fashion, and the transition metal (M = Fe, Co) has a distorted 4+1 square pyramidal coordination geometry. The Co(II) compound (3) crystallizes in the triclinic $P\overline{1}$ space group, with the unit cell containing one cis and three trans inequivalent [Co(II)(3cbdt)₂] complexes with the transition metal (Co) and having a square planar coordination geometry. The Fe(III) complex (1) is EPR-silent, and the static magnetic susceptibility shows a temperature dependence typical of dimers of antiferromagnetically coupled S = 3/2 spins with −J/k_B = 233.6 K and g = 1.8. Static magnetic susceptibility measurements of compound (3) show that this Co(II) complex is paramagnetic, corresponding to an S = ½ state with g = 2, in agreement with EPR spectra showing in solid state a hyperfine structure typical of the I(⁵⁹Co) = 7/2. Static susceptibility measurements of Co(III) complex (2) showed an increase in the paramagnetic susceptibility upon warming above 100 K, which is consistent with strong AFM coupling between dimerized S = 1 units with a constant −J/k_B ~1286 K. Full article

Advancements in the nuclear industry have led to the development of fully digitized main control rooms (MCRs)—often termed advanced MCRs—for newly built nuclear power plants (NPPs). Diagnosis is a major part of the cognitive activity in NPP MCRs. Advanced MCRs are expected to improve the working environment and reduce human error, especially during the diagnosis of unexpected scenarios. However, with the introduction of new types of tasks and errors by digital MCRs, a new method to analyze the diagnosis errors in these new types of MCRs is required. Task analysis for operator diagnosis in an advanced MCR based on emergency operation was performed to determine the error modes. The cause-based decision tree (CBDT) method—originally developed for analog control rooms—was then revised to a modified CBDT (MCBDT) based on the error mode categorizations. This work examines the possible adoption of the MCBDT method for the evaluation of diagnosis errors in advanced MCRs. We have also provided examples of the application of the proposed method to some common human failure events in emergency operations. The results show that with some modifications of the CBDT method, the human reliability in advanced MCRs can be reasonably estimated. Full article

Phytochemicals of Cannabis sativa mainly for the use in the different industries are that of delta-9-tetrahydrocannabinol (THC) and cannabidiol (CBD). Pressurized hot water extraction (PHWE) is seen as an efficient, fast, green extraction technique for the removal of polar and semi-polar compounds from plant materials. The PHWE technique was applied to extract cannabinoid compounds from Cannabis sativa seed. Response surface methodology was used to investigate the influence of extraction time (5–60 min), extraction temperature (50–200 °C) and collector vessel temperature (25–200 °C) on the recovery of delta-9-tetrahydrocannabinol (THC), cannabinol (CBN), cannabidiol (CBD), cannabichromene (CBG) and cannabigerol (CBC) from Cannabis sativa seed by PHWE. The identification and semi quantification of cannabinoid compounds were determined using GCXGC-TOFMS. The results obtained from different extractions show that the amount of THC and CBN was drastically decreasing in the liquid extract when the temperature rose from 140 to 160 °C in the extraction cell and the collector′s vessel. The optimal conditions to extract more CBD, CBC, and CBG than THC and CBN were set at 150 °C, 160 °C and 45 min as extraction temperature, the temperature at collector vessel, and the extraction time, respectively. At this condition, the predicted and experimental ratio of THCt (THC + CBN)/CBDt (CBD + CBC+ CBG) was found to be 0.17 and 0.18, respectively. Therefore, PHWE can be seen as an alternative to the classic extraction approach as the efficiency is higher and it is environmentally friendly. Full article