Search Results (68)

With the onset of 5G technology, the number of users is increasing drastically. These increased numbers of users demand better service on the network. This study examines the millimeter wave bands working frequencies. Working in the millimeter wave band has the disadvantage of interference. This study aims to analyze the impact of different interference conditions on unmanned aerial vehicle use scenarios, such as open-air gatherings and indoor-outdoor sports stadiums. Performance analysis was carried out in terms of received power and path loss readings. Full article

With the development of the Internet of Things (IoT), the number of devices will also increase tremendously. However, we need more wireless communication resources. It has been shown in the literature that non-orthogonal multiple access (NOMA) offers high multiplexing gains due to the simultaneous transfer of signals, and massive multiple-input–multiple-outputs (mMIMOs) offer high spectrum efficiency due to the high antenna gain and high multiplexing gains. Therefore, a downlink mMIMO NOMA cooperative system is considered in this paper. The users at the cell edge in 5G cellular system generally suffer from poor signal quality as they are far away from the BS and expend high battery power to decode the signals superimposed through NOMA. Thus, this paper uses a cooperative relay system and proposes the mMIMO NOMA double-mode model to reduce battery expenditure and increase the cell edge user’s energy efficiency and sum rate. In the mMIMO NOMA double-mode model, two modes of operation are defined. Depending on the relay’s battery level, these modes are chosen to utilize the system’s energy efficiency. Comprehensive numerical results show the improvement in the proposed system’s average sum rate and average energy efficiency compared with a conventional system. In a cooperative NOMA system, the base station (BS) transmits a signal to a relay, and the relay forwards the signal to a cluster of users. This cluster formation depends on the user positions and geographical restrictions concerning the relay equipment. Therefore, it is vital to form user clusters for efficient and simultaneous transmission. This paper also presents a novel method for efficient cluster formation. Full article

For constructing the best local codebook for image compression, there are many Vector Quantization (VQ) procedures, but the simplest VQ procedure is the Linde–Buzo–Gray (LBG) procedure. Techniques such as the Gaussian Dissemination Function (GDF) are used for the searching process in generating a global codebook for particle swarm optimization (PSO), Honeybee mating optimization (HBMO), and Firefly (FA) procedures. However, when particle velocity is very high, FA encounters a problem when brighter fireflies are trivial, and PSO suffers uncertainty in merging. A novel procedure, Cuckoo Search–Kekre Fast Codebook Generation (CS-KFCG), is proposed that enhances Cuckoo Search–Linde–Buzo–Gray (CS-LBG) codebook by implementing a Flight Dissemination Function (FDF), which produces more speed than other states of the art algorithms with appropriate mutation expectations for the overall codebook. Also, CS-KFGC has generated a high Peak Signal Noise Ratio (PSNR) in terms of high duration (time) and better acceptability rate. Full article

Credit card (CC) fraud has been a persistent problem and has affected financial organizations. Traditional machine learning (ML) algorithms are ineffective owing to the increased attack space, and techniques such as long short-term memory (LSTM) have shown promising results in detecting CC fraud patterns. However, owing to the black box nature of the LSTM model, the decision-making process could be improved. Thus, in this paper, we propose a scheme, RaKShA, which presents explainable artificial intelligence (XAI) to help understand and interpret the behavior of black box models. XAI is formally used to interpret these black box models; however, we used XAI to extract essential features from the CC fraud dataset, consequently improving the performance of the LSTM model. The XAI was integrated with LSTM to form an explainable LSTM (X-LSTM) model. The proposed approach takes preprocessed data and feeds it to the XAI model, which computes the variable importance plot for the dataset, which simplifies the feature selection. Then, the data are presented to the LSTM model, and the output classification is stored in a smart contract (SC), ensuring no tampering with the results. The final data are stored on the blockchain (BC), which forms trusted and chronological ledger entries. We have considered two open-source CC datasets. We obtain an accuracy of 99.8% with our proposed X-LSTM model over 50 epochs compared to 85% without XAI (simple LSTM model). We present the gas fee requirements, IPFS bandwidth, and the fraud detection contract specification in blockchain metrics. The proposed results indicate the practical viability of our scheme in real-financial CC spending and lending setups. Full article

Cardiovascular diseases (CVDs) are a significant cause of death worldwide. CVDs can be prevented by diagnosing heartbeat sounds and other conventional techniques early to reduce the harmful effects caused by CVDs. However, it is still challenging to segment, extract features, and predict heartbeat sounds in elderly people. The inception of deep learning (DL) algorithms has helped detect various types of heartbeat sounds at an early stage. Motivated by this, we proposed an intelligent architecture categorizing heartbeat into normal and murmurs for elderly people. We have used a standard heartbeat dataset with heartbeat class labels, i.e., normal and murmur. Furthermore, it is augmented and preprocessed by normalization and standardization to significantly reduce computational power and time. The proposed convolutional neural network and bi-directional gated recurrent unit (CNN + BiGRU) attention-based architecture for the classification of heartbeat sound achieves an accuracy of 90% compared to the baseline approaches. Hence, the proposed novel CNN + BiGRU attention-based architecture is superior to other DL models for heartbeat sound classification. Full article

Topic modeling is a machine learning algorithm based on statistics that follows unsupervised machine learning techniques for mapping a high-dimensional corpus to a low-dimensional topical subspace, but it could be better. A topic model’s topic is expected to be interpretable as a concept, i.e., correspond to human understanding of a topic occurring in texts. While discovering corpus themes, inference constantly uses vocabulary that impacts topic quality due to its size. Inflectional forms are in the corpus. Since words frequently appear in the same sentence and are likely to have a latent topic, practically all topic models rely on co-occurrence signals between various terms in the corpus. The topics get weaker because of the abundance of distinct tokens in languages with extensive inflectional morphology. Lemmatization is often used to preempt this problem. Gujarati is one of the morphologically rich languages, as a word may have several inflectional forms. This paper proposes a deterministic finite automaton (DFA) based lemmatization technique for the Gujarati language to transform lemmas into their root words. The set of topics is then inferred from this lemmatized corpus of Gujarati text. We employ statistical divergence measurements to identify semantically less coherent (overly general) topics. The result shows that the lemmatized Gujarati corpus learns more interpretable and meaningful subjects than unlemmatized text. Finally, results show that lemmatization curtails the size of vocabulary decreases by 16% and the semantic coherence for all three measurements—Log Conditional Probability, Pointwise Mutual Information, and Normalized Pointwise Mutual Information—from −9.39 to −7.49, −6.79 to −5.18, and −0.23 to −0.17, respectively. Full article

The Metaverse allows the integration of physical and digital versions of users, processes, and environments where entities communicate, transact, and socialize. With the shift towards Extended Reality (XR) technologies, the Metaverse is envisioned to support a wide range of applicative verticals. It will support a seamless mix of physical and virtual worlds (realities) and, thus, will be a game changer for the Future Internet, built on the Semantic Web framework. The Metaverse will be ably assisted by the convergence of emerging wireless communication networks (such as Fifth-Generation and Beyond networks) or Sixth-Generation (6G) networks, Blockchain (BC), Web 3.0, Artificial Intelligence (AI), and Non-Fungible Tokens (NFTs). It has the potential for convergence in diverse industrial applications such as digital twins, telehealth care, connected vehicles, virtual education, social networks, and financial applications. Recent studies on the Metaverse have focused on explaining its key components, but a systematic study of the Metaverse in terms of industrial applications has not yet been performed. Owing to this gap, this survey presents the salient features and assistive Metaverse technologies. We discuss a high-level and generic Metaverse framework for modern industrial cyberspace and discuss the potential challenges and future directions of the Metaverse’s realization. A case study on Metaverse-assisted Real Estate Management (REM) is presented, where the Metaverse governs a Buyer–Broker–Seller (BBS) architecture for land registrations. We discuss the performance evaluation of the current land registration ecosystem in terms of cost evaluation, trust probability, and mining cost on the BC network. The obtained results show the viability of the Metaverse in REM setups. Full article

In the current era, the skyrocketing demand for energy necessitates a powerful mechanism to mitigate the supply–demand gap in intelligent energy infrastructure, i.e., the smart grid. To handle this issue, an intelligent and secure energy management system (EMS) could benefit end-consumers participating in the Demand–Response (DR) program. Therefore, in this paper, we proposed a real-time and secure incentive-based EMS for smart grid, i.e., RI-EMS approach using Reinforcement Learning (RL) and blockchain technology. In the RI-EMS approach, we proposed a novel reward mechanism for better convergence of the RL-based model using a Q-learning approach based on the greedy policy that guides the RL-agent for faster convergence. Then, the proposed RI-EMS approach designed a real-time incentive mechanism to minimize energy consumption in peak hours and reduce end-consumers’ energy bills to provide incentives to the end-consumers. Experimental results show that the proposed RI-EMS approach induces end-consumer participation and increases customer profitabilities compared to existing approaches considering the different performance evaluation metrics such as energy consumption for end-consumers, energy consumption reduction, and total cost comparison to end-consumers. Furthermore, blockchain-based results are simulated and analyzed with the help of deployed smart contracts in a Remix Integrated Development Environment (IDE) with the parameters such as transaction efficiency and data storage cost. Full article

A cognitive radio network (CRN) is an intelligent network that can detect unoccupied spectrum space without interfering with the primary user (PU). Spectrum scarcity arises due to the stable channel allocation, which the CRN handles. Spectrum handoff management is a critical problem that must be addressed in the CRN to ensure indefinite connection and profitable use of unallocated spectrum space for secondary users (SUs). Spectrum handoff (SHO) has some disadvantages, i.e., communication delay and power consumption. To overcome these drawbacks, a reduction in handoff should be a priority. This study proposes the use of dynamic spectrum access (DSA) to check for available channels for SU during handoff using a metaheuristic algorithm depending on machine learning. The simulation results show that the proposed “support vector machine-based red deer algorithm” (SVM-RDA) is resilient and has low complexity. The suggested algorithm’s experimental setup offers several handoffs, unsuccessful handoffs, handoff delay, throughput, signal-to-noise ratio (SNR), SU bandwidth, and total spectrum bandwidth. This study provides an improved system performance during SHO. The inferred technique anticipates handoff delay and minimizes the handoff numbers. The results show that the recommended method is better at making predictions with fewer handoffs compared to the other three. Full article

The topic addressed in this article is part of the current concerns of modernizing power systems by promoting and implementing the concept of smart grid(s). The concepts of smart metering, a smart home, and an electric car are developing simultaneously with the idea of a smart city by developing high-performance electrical equipment and systems, telecommunications technologies, and computing and infrastructure based on artificial intelligence algorithms. The article presents contributions regarding the modeling of consumer classification and load profiling in electrical power networks and the efficiency of clustering techniques in their profiling as well as the simulation of the load of medium-voltage/low-voltage network distribution transformers to electricity meters. Full article

The physical world can be controlled directly over the Internet once a Cyber-Physical 1 System (CPS) infrastructure is established. The Intelligent Transportation System (ITS) encompasses Wireless Sensor Network (WSN), Vehicular ad hoc network (VANET), and 5G-enabled Internet of Things (IoT) solutions to transform traditional transportation into an ITS. This research investigates the option of running a blockchain-driven security assurance model to safeguard intelligent roads and smart vehicles as part of ITS. The proposed model considers a semi-distributed model in blockchain deployment to ensure satisfactory Internet of Vehicles (IoV) service while mining acceptable security assurance. The experimental outcomes on intelligent roads and smart parking management indicate that the proposed model achieves comparably good data delivery and reduced latency, paving the way to an innovative deployment of blockchain technologies in IoV for a dependable and trustworthy ITS. Full article

Over the last few decades, the healthcare industry has continuously grown, with hundreds of thousands of patients obtaining treatment remotely using smart devices. Data security becomes a prime concern with such a massive increase in the number of patients. Numerous attacks on healthcare data have recently been identified that can put the patient’s identity at stake. For example, the private data of millions of patients have been published online, posing a severe risk to patients’ data privacy. However, with the advent of Industry 4.0, medical practitioners can digitally assess the patient’s condition and administer prompt prescriptions. However, wearable devices are also vulnerable to numerous security threats, such as session hijacking, data manipulation, and spoofing attacks. Attackers can tamper with the patient’s wearable device and relays the tampered data to the concerned doctor. This can put the patient’s life at high risk. Since blockchain is a transparent and immutable decentralized system, it can be utilized for securely storing patient’s wearable data. Artificial Intelligence (AI), on the other hand, utilizes different machine learning techniques to classify malicious data from an oncoming stream of patient’s wearable data. An amalgamation of these two technologies would make the possibility of tampering the patient’s data extremely difficult. To mitigate the aforementioned issues, this paper proposes a blockchain and AI-envisioned secure and trusted framework (HEART). Here, Long-Short Term Model (LSTM) is used to classify wearable devices as malicious or non-malicious. Then, we design a smart contract that allows only of those patients’ data having a wearable device to be classified as non-malicious to the public blockchain network. This information is then accessible to all involved in the patient’s care. We then evaluate the HEART’s performance considering various evaluation metrics such as accuracy, recall, precision, scalability, and network latency. On the training and testing sets, the model achieves accuracies of 93% and 92.92%, respectively. Full article

The Vehicular Ad-hoc Network (VANET) is an innovative technology that allows vehicles to connect with neighboring roadside structures to deliver intelligent transportation applications. To deliver safe communication among vehicles, a reliable routing approach is required. Due to the excessive mobility and frequent variation in network topology, establishing a reliable routing for VANETs takes a lot of work. In VANETs, transmission links are extremely susceptible to interruption; as a result, the routing efficiency of these constantly evolving networks requires special attention. To promote reliable routing in VANETs, we propose a novel context-aware reliable routing protocol that integrates k-means clustering and support vector machine (SVM) in this paper. The k-means clustering divides the routes into two clusters named GOOD and BAD. The cluster with high mean square error (MSE) is labelled as BAD, and the cluster with low MSE is labelled as GOOD. After training the routing data with SVM, the performance of each route from source to target is improved in terms of Packet Delivery Ratio (PDR), throughput, and End to End Delay (E2E). The proposed protocol will achieve improved routing efficiency with these changes. Full article