Next Article in Journal
Mixed Carbon Nanomaterial/Epoxy Resin for Electrically Conductive Adhesives
Next Article in Special Issue
Selective Laser Sintering of PA6: Effect of Powder Recoating on Fibre Orientation
Previous Article in Journal
Recycling Waste Tires into Ground Tire Rubber (GTR)/Rubber Compounds: A Review
Previous Article in Special Issue
A Flow-Dependent Fiber Orientation Model
 
 
Article
Peer-Review Record

Measuring Fiber Length in the Core and Shell Regions of Injection Molded Long Fiber-Reinforced Thermoplastic Plaques

J. Compos. Sci. 2020, 4(3), 104; https://doi.org/10.3390/jcs4030104
by Abrahán Bechara Senior * and Tim Osswald
Reviewer 1: Anonymous
Reviewer 2: Anonymous
J. Compos. Sci. 2020, 4(3), 104; https://doi.org/10.3390/jcs4030104
Submission received: 29 June 2020 / Revised: 29 July 2020 / Accepted: 29 July 2020 / Published: 31 July 2020
(This article belongs to the Special Issue Discontinuous Fiber Composites, Volume II)

Round 1

Reviewer 1 Report

Dear Authors,

Thank you for submitting your work in Journal of Composite Sciences titled "Measuring Fiber Length in the Core and Shell Regions of Injection Molded Long Fiber-Reinforced Thermoplastic Plaques".

I have made a thorough review and overall found the paper to be written in a very good english and the technical quality of the paper also warrants merit. However I have minor corrections suggested for authors in the attached pdf. Please carefully go through the comments and accordingly revise and resubmit the manuscript. 

 

Thanks and Good Luck

Comments for author File: Comments.pdf

Author Response

Please see the attachment

Author Response File: Author Response.pdf

Reviewer 2 Report

The manuscript describes a process to measure fiber length in the core and shell
regions of injection molded composites. This fiber length difference and its impact on composite properties have been reported and explained in literature, so the contribution of the manuscript rests with the measurement process itself. The actual measurement is based on computer image processing which is also  reported in literature. In addition, more advanced material analysis technique such as synchrotron can enable the measurement of material morphology of any layer through the thickness.  Thus, the novelty of the manuscript is modest.

The manuscript is well written, but the validation experiment is not easy to follow. It is difficult to understand how the core and sheath fiber difference was controlled.  

Author Response

Please see the attachment

Author Response File: Author Response.pdf

Back to TopTop