Next Article in Journal
Advances in BBB on Chip and Application for Studying Reversible Opening of Blood–Brain Barrier by Sonoporation
Next Article in Special Issue
Triboelectric-Electromagnetic Hybrid Wind-Energy Harvester with a Low Startup Wind Speed in Urban Self-Powered Sensing
Previous Article in Journal
2-Dimensional (2D) Beam Steering-Antenna Using Active PRS for 5G Applications
Previous Article in Special Issue
A Framework to Predict Gastric Cancer Based on Tongue Features and Deep Learning
 
 
Article
Peer-Review Record

Flexible Capacitive Pressure Sensor Based on a Double-Sided Microstructure Porous Dielectric Layer

Micromachines 2023, 14(1), 111; https://doi.org/10.3390/mi14010111
by Qingyang Yu 1,* and Jian Zhang 2
Reviewer 2:
Micromachines 2023, 14(1), 111; https://doi.org/10.3390/mi14010111
Submission received: 7 November 2022 / Revised: 29 November 2022 / Accepted: 2 December 2022 / Published: 30 December 2022
(This article belongs to the Special Issue Flexible and Wearable Sensors)

Round 1

Reviewer 1 Report

Refer to file for comments.

Comments for author File: Comments.docx

Author Response

Please see the attachment.

Author Response File: Author Response.docx

Reviewer 2 Report

In the present manuscript, authors have have  fabricated flexible capacitive pressure sensor arrays and device performance was measured. Manuscript is well written and provide sufficient data with quality. Reviewer has positive opinion for acceptance of the manuscript. However, I have one concern regarding device endurance. Can they show active layer and electrode microstructural features after sufficient number of flexibility test of the device? However, this is not a strict requirement.  

Author Response

Please see the attachment

Author Response File: Author Response.docx

Round 2

Reviewer 1 Report

The SEM figure has some dimensions/text that is difficult to read. If it's not important to the narrative, consider using SEM images without the measurements.

Overall the improvements are good.

Back to TopTop