Next Article in Journal
Injection Moulding into 3D-Printed Plastic Inserts Produced Using the Multi Jet Fusion Method
Next Article in Special Issue
Dynamic Characteristic Analysis of a Toothed Electromagnetic Spring Based on the Improved Bouc—Wen Model
Previous Article in Journal
Investigation of Asphalt Self-Healing Capability Using Microvasculars Containing Rejuvenator: Effects of Microvascular Content, Self-Healing Time and Temperature
 
 
Article
Peer-Review Record

Investigation on Vibration Characteristics of Thin-Walled Steel Structures under Shock Waves

Materials 2023, 16(13), 4748; https://doi.org/10.3390/ma16134748
by Zehao Li 1, Wenlong Xu 1,*, Cheng Wang 2,*, Xin Liu 2 and Yuanxiang Sun 2
Reviewer 1: Anonymous
Reviewer 2: Anonymous
Materials 2023, 16(13), 4748; https://doi.org/10.3390/ma16134748
Submission received: 31 May 2023 / Revised: 23 June 2023 / Accepted: 27 June 2023 / Published: 30 June 2023
(This article belongs to the Special Issue Dynamic Behavior of Advanced Materials and Structures)

Round 1

Reviewer 1 Report

Dear authors,

I am of the opinion that the paper has good potential. However, it should be improved a bit.

In the paper, you do not specify which steel material it is. It would be good to state what the material is and its mechanical characteristics.

The tests were performed only on one steel plate with a thickness of 4 mm. Why was that particular thickness chosen and what would the results be if a steel plate of a different thickness were chosen?

What is the purpose of this examination and how can this knowledge be applied in practice when determining the dimensions of elements? Is it possible to perform numerical modelling based on this knowledge?

In the conclusion, the results and meaning of these tests should be explained in more detail.

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Reviewer 2 Report

The work presented in the manuscript is novel. The following points need to be addressed before publication. 

1) In the introduction states, "Hermite interpolation was proposed". What is the purpose? Write 01 line explanation. 

2) In the introduction, remove the sentence from the chapters. 

3) In the experimental setup, states "was partitioned into high-pressure and low-pressure sections, separated". Provide the approximate pressure values. 

4) Provide the details of steel materials. 

 

Minor editing of the English language required

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Round 2

Reviewer 1 Report

The authors made corrections in the paper according to the instructions of the reviewers and the paper can be published.

Back to TopTop