Search Results (6)

This study aimed to assess the effect of salting and ripening conditions on the features of sheep milk, reduced-fat, semi-hard cheese. Eight groups of cheese, with an average fat content of ≅10.5%, moisture on non-fat substances (MNFS) ≅ 56%, a protein-to-fat ratio of 2.9 and pH 5.1, were manufactured and analyzed throughout ripening. The experimental factors were the salting method (brine- or dry-salting), the salt content (control- and reduced-salt) and the ripening temperature sequence (11 or 18 °C at the 3rd and 4th week). Brine-salted cheese exhibited significantly more adequate (p < 0.05) textural and organoleptic characteristics compared to its dry-salted counterpart, i.e., lower hardness, gumminess and adhesiveness, with higher lightness and flavor scores. The mean salt reduction from 2.1 to 1.6% exhibited significant effects (p < 0.05), i.e., increased moisture and MNFS, decreased hardness, gumminess, chewiness and adhesiveness, and increased lightness and meltability of cheese without affecting the microbiological stability or impairing the organoleptic parameters. Ripening at 18 °C at weeks 3–4 significantly increased (p < 0.05) proteolysis and concentrations of lactic and citric acid without affecting meltability, textural or organoleptic features. In conclusion, brine-salting, salt reduction by 20% and the elevation of temperature at a particular ripening period improved the characteristics of this type of reduced-fat sheep milk cheese. Full article

The aim of the present study was to analyze the impact of cheese fragmentation and packaging on the dynamics of water–fat serum released from pasta filata cheese made from cow’s milk and its mixture with sheep’s milk. The addition of sheep’s milk reduced the amount of leachate from the vacuum-packed cheeses and did not cause as much loss of gloss as in the case of cow’s milk cheeses. This was also reflected in the microscopic images of the cheese samples. Consumers showed less acceptance of cow’s milk pasta filata cheeses than cheeses made with a mixture of cow’s and sheep’s milk (they had the same fat content, acidity, hardness, and oiling-off, but better stretching). The data describing water–fat serum release from pasta filata cheese within 24 h of unpacking was modeled with the use of the feed-forward artificial neural networks, whose architecture is based on Multi-Layer Perceptron with a single hidden layer. The model inputs comprised four independent variables, including one quantitative (i.e., time) and the other qualitative ones, which had the following states: type of raw material (cow’s milk, cow-sheep’s milk), way of sample portioning (whole, quarters, slices), packing method (vacuum packed and packed in brine). Full article

The purpose of this work was to study the suitability of the water-soluble extracts (WSE) of semi-hard sheep milk cheese for analysis by diffuse reflectance Fourier transform mid-infrared spectroscopy (FT-MIR) and the development of classification models using discriminant analysis and based on cheese age or phospholipid content. WSE was extracted from three types of sheep milk cheeses (full-fat, reduced-fat and reduced-fat fortified with lyophilized sweet sheep buttermilk) at various stages of ripening from six to 168 days and lyophilized. The first model used 1854–1381 and 1192–760 cm⁻¹ regions of the first-derivative spectra and successfully differentiated samples of different age, based on changes in the water-soluble products of ripening biochemical events. The second model used the phospholipid absorbance spectral regions (3012–2851, 1854–1611 and 1192–909 cm⁻¹) to successfully discriminate cheeses of markedly different phospholipid content. Cheese WSE was found suitable for FT-MIR analysis. According to the results, a fast and simple method to monitor cheese ripening based on water-soluble substances has been developed. Additionally, the results indicated that a considerable amount of phospholipids migrates to the cheese WSE and that FT-MIR can be a useful tool for their assessment. Full article

β-Glucan, isolated from the mushroom Pleurotus ostreatus, at a concentration of 0.4%, was used in the manufacture of reduced-fat white-brined cheese from sheep milk. Control reduced-fat cheese was also produced from the same milk without the addition of β-glucan. The resultant cheeses were examined for their physicochemical characteristics, color and textural properties, and level of proteolysis and lipolysis. Furthermore, cheeses were evaluated organoleptically. In general, there were no statistical differences in the physicochemical characteristics and proteolysis levels found between both cheeses. The addition of β-glucan improved textural properties, and the cheeses received favorable grades for all the organoleptic characteristics. There were no flavor defects (such as a bitter taste) described by the panellists in this study. Generally, the addition of β-glucan did not significantly affect total free fatty acid content; however, at 180 days of ripening and storage, cheeses with the addition of β-glucan had a higher (p < 0.05) content than cheeses without β-glucan. The major fatty acids were acetic acid and capric acid. Full article

In the following study, three different dairy by-products, previously concentrated by ultrafiltration (UF), were used as ingredients in the production of reduced-fat (RF) washed curd cheeses in order to improve their characteristics. Conventional full-fat (FF) cheeses (45% fat, dry basis (db)) and RF cheeses (20–30% fat, db) were compared to RF cheeses produced with the incorporation of 5% concentrated whey (RF + CW), buttermilk (RF + CB) or sheep second cheese whey (RF + CS). Protein-to-fat ratios were lower than 1 in the FF cheeses, while RF cheeses ranged from 1.8 to 2.8. The tested by-products performed differently when added to the milk used for cheese production. The FF cheese showed a more pronounced yellow colour after 60 and 90 days of ripening, indicating that fat plays an important role regarding this parameter. As far as the texture parameters are concerned, after 60 days of ripening, RF cheeses with buttermilk presented similar results to FF cheeses for hardness (5.0–7.5 N) and chewiness (ca. 400). These were lower than the ones recorded for RF cheeses with added UF concentrated whey (RF + CW) and second cheese whey (RF + CS), which presented lower adhesiveness values. RF cheeses with 5% incorporation of buttermilk concentrated by UF presented the best results concerning both texture and sensory evaluation. Full article

This paper examines the effects of the incorporation of denatured whey proteins along with salting in NaCl/KCl brine on the characteristics and ripening of sheep milk reduced-fat (RF), semi-hard cheese. Incorporation of denatured whey proteins was carried out by: i. adding commercial microparticulated whey protein (MWP) in reduced-fat cheese milk (RFM), or ii. by ‘in situ’ heat-induced partial denaturation of whey proteins of reduced-fat cheese milk (RFD). The implemented cheesemaking conditions included curd washing, moderate clotting, scalding temperatures, and ripening of cheeses packed in plastic bags under vacuum at 10 °C. Full-fat cheeses (FF) were manufactured in parallel. Physicochemical composition, textural profile, and proteolysis were assessed throughout 60 days of ripening. The mean moisture, fat on dry matter (FDM), moisture on non-fat substances (MNFS), protein on dry matter (PDM), salt, and salt-in-moisture (S/M) content of the RF cheeses were 47.4%, 32.8%, 57.3%, 54.3%, 1.63%, and 3.36%, respectively; pH ≈ 5.0, a_w ≈ 0.977, Ca ≈ 1000 mg/100 g cheese. The MNFS of FF and RF cheeses were similar. Proteolysis indices were not affected by any of the treatments, and they were similar to the FF counterparts. The applied cheesemaking technology was adequate for the production of semi-hard reduced-fat and reduced-sodium cheeses. Ripening under packaging hindered moisture loss without impairing the evolution of proteolysis and textural parameters. The same holds true for salting in NaCl/KCl brine. The high pasteurization of cheese milk was more effective for the increase of moisture and MNFS than the addition of MWP, without exhibiting any adverse effects. Full article