Search Results (3)

Magnetic Functional Nanomaterials Co_1−yZn_yRE_xFe_2−xO₄ (RE (rare-earth) = La,Sm,Gd) were prepared using the sol–gel combustion method. XRD characterization confirms that the ferrite samples we synthesized are single-phase cubic structures. The variation in the average crystalline size and lattice parameter is related to RE ion doping. The Mössbauer spectra of CoRE_xFe_2−xO₄ are two sets of magnetic six-wire peaks that indicate the ferrimagnetic behavior of the sample. The calcination temperature greatly influences the absorption area of Mössbauer for CoFe₂O₄, indicating that the calcination temperature affects the iron ion content at the octahedral B and tetrahedral A sites. Additionally, scanning electron microscopy measurements of the substituted specimens reveal that the ferrite powders are nanoparticles. With an increase in RE ions, the coercivity increases, and the saturation magnetization changes obviously. The XRD characterization of Co_0.7Zn_0.3La_xFe_2−xO₄ shows that the main crystalline phase of the sample is the cubic spinel structure phase, and there are fewer secondary crystalline phases. The lattice parameter tends to decrease with the substitution of La³⁺ ions. The average grain size decreased significantly with the increase in La content. From ferrimagnetic state transition to relaxation behavior, the hyperfine magnetic field decreases in La concentration by room temperature Mössbauer spectra. With the substitution of La³⁺ ions, both the saturation magnetization and coercivity of the samples were reduced, and the coercivity of all samples was lower. Full article

The synthesis and characterization of multicolor light-emitting nanomaterials based on rare earths (RE³⁺) are of great importance due to their possible use in optoelectronic devices, such as LEDs or displays. In the present work, oxyfluoride glass-ceramics containing BaF₂ nanocrystals co-doped with Tb³⁺, Eu³⁺ ions were fabricated from amorphous xerogels at 350 °C. The analysis of the thermal behavior of fabricated xerogels was performed using TG/DSC measurements (thermogravimetry (TG), differential scanning calorimetry (DSC)). The crystallization of BaF₂ phase at the nanoscale was confirmed by X-ray diffraction (XRD) measurements and transmission electron microscopy (TEM), and the changes in silicate sol–gel host were determined by attenuated total reflectance infrared (ATR-IR) spectroscopy. The luminescent characterization of prepared sol–gel materials was carried out by excitation and emission spectra along with decay analysis from the ⁵D₄ level of Tb³⁺. As a result, the visible light according to the electronic transitions of Tb³⁺ (⁵D₄ → ⁷F_J (J = 6–3)) and Eu³⁺ (⁵D₀ → ⁷F_J (J = 0–4)) was recorded. It was also observed that co-doping with Eu³⁺ caused the shortening in decay times of the ⁵D₄ state from 1.11 ms to 0.88 ms (for xerogels) and from 6.56 ms to 4.06 ms (for glass-ceramics). Thus, based on lifetime values, the Tb³⁺/Eu³⁺ energy transfer (ET) efficiencies were estimated to be almost 21% for xerogels and 38% for nano-glass-ceramics. Therefore, such materials could be successfully predisposed for laser technologies, spectral converters, and three-dimensional displays. Full article

Organic-inorganic lead halide based perovskite solar cells have received broad interest due to their merits of low fabrication cost, a low temperature solution process, and high energy conversion efficiencies. Rare-earth (RE) ion doped nanomaterials can be used in perovskite solar cells to expand the range of absorption spectra and improve the stability due to its upconversion and downconversion effect. This article reviews recent progress in using RE-ion-doped nanomaterials in mesoporous electrodes, perovskite active layers, and as an external function layer of perovskite solar cells. Finally, we discuss the challenges facing the effective use of RE-ion-doped nanomaterials in perovskite solar cells and present some prospects for future research. Full article