Search Results (3)

One of the most effective methods to limit the mechanical vibrations of bladed disks is the use of friction damping at mechanical joint interfaces. Unfortunately, dedicated tests to assess the impact of mistuning and the effectiveness of friction dampers are uncommon. This paper presents an original design of an academic demonstrator to perform an experimental analysis of the dynamic response of a tip-free bladed disk with under-platform dampers (UPDs), including an identification of intrinsic and contact mistuning introduced by the UPDs. The 48-blade disk was tested in a vacuum spinning rig by using permanent magnets. Vibration measurements were performed with the Blade Tip-Timing system. Tests were simulated using the Policontact tool, which predicted the average experimental nonlinear response in the presence of UPD, confirming the tool’s ability to capture the general nonlinear dynamic behavior of the mistuned bladed disk. This study presents a novel approach combining experimental Blade Tip Timing (BTT) with numerical simulations using Policontact (ver. 3.0) software and a model update based on experimental evidence to validate nonlinear dynamic responses. It distinguishes between intrinsic and contact mistuning effects, providing new insights into their impact on bladed disk vibrations. Additionally, a comparison of aluminum and steel UPDs reveals that steel offers a 26% greater damping efficiency due to its higher density and preload, significantly improving vibration reduction. Full article

In this study, a thorough experimental investigation of the synchronous blade vibrations of a radial turbine is performed for different IGV configurations. First, the blade modes are measured experimentally and calculated numerically. Subsequently, the vibrations are recorded with two redundant measurement systems during real operation. Strain gauges were applied on certain blades, while a commercial blade-tip-timing system is used for the measurement of blade deflections. The experimentally determined vibration properties are compared with numerical estimations. Initially, the vibrations recorded with the “nominal” IGV were presented. This IGV primarily generates nodal diameter (ND) 0 vibrations. Subsequently, the impact of two different IGV configurations is examined. First, a mistuned IGV, which has the same number of vanes as the “nominal” IGV is examined. By intentionally varying the distance between the vanes, additional low engine order excitations are generated. Moreover, an IGV with a higher number of vanes is employed to induce excitations at higher frequency modes and ND6 vibrations. Certain vibrations are consistently measured across all IGV configurations, which cannot be attributed to the spiral turbine casing. In addition, a turbine–compressor interaction has been observed. Full article

The manufacturing geometrical variability in axial compressors is a stochastic source of uncertainty, implying that the real geometry differs from the nominal design. This causes the real geometry to lose the ideal axial symmetry. Considering the aerofoils of a stator vane, the geometrical variability affects the flow traversing it. This impacts the downstream rotor, especially when considering the aeroelastic excitation forces. Optical surface scans coupled with a parametrisation method allow for acquiring the information relative to the real aerofoils geometries. The measured data are included in a multi-passage and multi-stage CFD setup to represent the mistuned flow. In particular, low excitation harmonics on the rotor vane are introduced due to the geometrical deviations of the upstream stator. The introduced low engine orders, as well as their amplitude, depend on the stator geometries and their order. A method is proposed to represent the phenomena in a reduced CFD domain, limiting the size and number of solutions required to probabilistically describe the rotor excitation forces. The resulting rotor excitation forces are reconstructed as a superposition of disturbances due to individual stator aerofoils geometries. This indicates that the problem is linear in the combination of disturbances from single passages. Full article