Search Results (7)

Providing safe drinking water free of heavy metal ions like iron and oxyanions like sulfate has become a worldwide issue. Starch, as one of the widely cheapest and available biomaterials, has demonstrated its capability to adsorb heavy metal ions from water in various scientific research, but in low adsorption rates. Therefore, this paper aims to prepare a biopolymer based on a starch–chitosan blend to raise the adsorption efficiency of starch. Two types of chitosan were used to modify potato starch (ps): low molecular chitosan (ch60) and high molecular chitosan (ch4000). Nano potato starch (n.ps) was prepared from potato starch and was also modified with both chitosans. The surface property, the morphology, the particle size, and the structure of the samples were analyzed. Moreover, the investigation of the samples by the zeta potential and charge density were evaluated to determine the charge of the adsorbents’ surface. Furthermore, the pseudo first order (PFO) and pseudo second order (PSO) were employed to examine the adsorption kinetic. The adsorption isotherms of Fe^2+/3+ and SO₄²⁻ were fitted employing Langmuir, Sips, and Dubinin-Radushkevich adsorption models. The maximum achieved sorption capacities from the FeSO₄ solution for Fe^2+/3+ were as follows: 115 mg/g for n.ps & ch4000, 90 mg/g for ps & ch4000, 80 mg/g for n.ps & ch60, and 61 mg/g for ps & ch60. Similarly, for SO₄²⁻, it was 192 mg/g for n.ps & ch4000, 155 mg/g for n.ps & ch60, 137 mg/g for ps & ch4000, and 97 mg/g for ps & ch60. Full article

The direct use of nanosorbents for water purification is limited due to their aggregation and the lack of techniques for their recovery from natural waters. To overcome these problems, the affixation of nanomaterials onto bulk, non-mobile supports has been proposed. However, a method to simulate the efficiency of these sorbents under realistic conditions is still not available. To address this need, this work describes a method for evaluating the sorption efficiency of nanosorbent materials incorporated on bulk supports under non-equilibrium conditions. The method combines the principles of passive sampling, an environmental monitoring technique that is based on passive diffusion of dissolved contaminants from water to a sorbent, with batch sorption experiments that measure sorption under equilibrium conditions, to determine the parameters associated with water purification. These parameters are the maximum sorption capacity of the sorbent and the sampling rate, which is the volume of contaminated water treated per unit of time. From these variables, the deployment time of the sorbent until reaching saturation is proposed as an alternative indicator of sorbent efficiency. As proof-of-principle, the removal of oxyanions from a Zr-metal-organic framework (MOR−1) immobilized on cotton textiles was investigated. The results show that the sorption capacity under passive diffusion uptake conditions, is approximately 20 mg/g for As(VI) and 36 mg/g Se(IV), which is 10 to 30 times lower compared to that determined in batch sorption studies, indicating that conventional equilibrium sorption overestimates the efficiency of the sorbents under realistic conditions. The application of the method to a worst-case scenario, involving the severe contamination of freshwaters with arsenate species, is also demonstrated. Full article

Nowadays, pollution has become the main bottleneck towards sustainable technological development due to its detrimental implications in human and ecosystem health. Removal of pollutants from the surrounding environment is a hot research area worldwide; diverse technologies and materials are being continuously developed. To this end, bio-based composite hydrogels as sorbents have received extensive attention in recent years because of advantages such as high adsorptive capacity, controllable mechanical properties, cost effectiveness, and potential for upscaling in continuous flow installations. In this review, we aim to provide an up-to-date analysis of the literature on recent accomplishments in the design of polysaccharide-based composite hydrogels for removal of heavy metal ions, dyes, and oxyanions from wastewater. The correlation between the constituent polysaccharides (chitosan, cellulose, alginate, starch, pectin, pullulan, xanthan, salecan, etc.), engineered composition (presence of other organic and/or inorganic components), and sorption conditions on the removal performance of addressed pollutants will be carefully scrutinized. Particular attention will be paid to the sustainability aspects in the selected studies, particularly to composite selectivity and reusability, as well as to their use in fixed-bed columns and real wastewater applications. Full article

Geopolymers, as a kind of inorganic polymer, possess excellent properties and have been broadly studied for the stabilization/solidification (S/S) of hazardous pollutants. Even though many reviews about geopolymers have been published, the summary of geopolymer-based S/S for various contaminants has not been well conducted. Therefore, the S/S of hazardous pollutants using geopolymers are comprehensively summarized in this review. Geopolymer-based S/S of typical cations, including Pb, Zn, Cd, Cs, Cu, Sr, Ni, etc., were involved and elucidated. The S/S mechanisms for cationic heavy metals were concluded, mainly including physical encapsulation, sorption, precipitation, and bonding with a silicate structure. In addition, compared to cationic ions, geopolymers have a poor immobilization ability on anions due to the repulsive effect between them, presenting a high leaching percentage. However, some anions, such as Se or As oxyanions, have been proved to exist in geopolymers through electrostatic interaction, which provides a direction to enhance the geopolymer-based S/S for anions. Besides, few reports about geopolymer-based S/S of organic pollutants have been published. Furthermore, the adsorbents of geopolymer-based composites designed and studied for the removal of hazardous pollutants from aqueous conditions are also briefly discussed. On the whole, this review will offer insights into geopolymer-based S/S technology. Furthermore, the challenges to geopolymer-based S/S technology outlined in this work are expected to be of direct relevance to the focus of future research. Full article

Scientific development has increased the awareness of water pollutant forms and has reawakened the need for its effective purification. Oxyanions are created by a variety of redox-sensitive metals and metalloids. These species are harmful to living matter due to their toxicity, nondegradibility, and mobility in aquatic environments. Among a variety of water treatment techniques, adsorption is one of the simplest, cheapest, and most effective. Since metal-oxide-based adsorbents poses a variety of functional groups onto their surface, they were widely applied in ions sorption. In this paper adsorption of harmful oxyanions by metal oxide-based materials according to literature survey was studied. Characteristic of oxyanions originating from As, V, B, W and Mo, their probable adsorption mechanisms and comparison of their sorption affinity for metal-oxide-based materials such as iron oxides, aluminum oxides, titanium dioxide, manganium dioxide, and various oxide minerals and their combinations are presented in this paper. Full article

Zhovty Vody city, located in south-central Ukraine, has long been an important center for the Ukrainian uranium and iron industries. Uranium and iron mining and processing activities during the Cold War resulted in poorly managed sources of radionuclides and heavy metals. Widespread groundwater and surface water contamination has occurred, which creates a significant risk to drinking water supplies. Hydrogeologic and geochemical conditions near large uranium mine tailings storage facility (TSF) were characterized to provide data to locate, design and install a permeable reactive barrier (PRB) to treat groundwater contaminated by leachate infiltrating from the TSF. The effectiveness of three different permeable reactive materials was investigated: zero-valent iron (ZVI) for reduction, sorption, and precipitation of redox-sensitive oxyanions; phosphate material to transform dissolved metals to less soluble phases; and organic carbon substrates to promote bioremediation processes. Batch and column experiments with Zhovty Vody site groundwater were conducted to evaluate reactivity of the materials. Reaction rates, residence time and comparison with site-specific clean-up standards were determined. Results of the study demonstrate the effectiveness of the use of the PRB for ground water protection near uranium mine TSF. The greatest decrease was obtained using ZVI-based reactive media and the combined media of ZVI/phosphate/organic carbon combinations. Full article

Iron oxide minerals, schwertmannite and goethite, which are naturally occurring in acidic environments are attractive nanostructured materials because of the potential diverse applications. Although the biosynthesis of schwertmannite by acidophilic Fe(II)-oxidizing microorganisms has been investigated, little is known about goethite biosynthesis under acidic conditions. To examine a biological approach to the synthesis of these minerals, bioreactor experiments were conducted with a newly isolated acidophilic betaproteobacterium. The bioproducts were characterized by powder X-ray diffraction, cryogenic Mössbauer spectroscopy, and electron microscopy. The cultures growing at 25 °C and pH 3.0 or at 37 °C and pH 2.5 oxidized Fe(II) and precipitated schwertmannite rapidly. Increasing pH at each temperature resulted in the concomitant production of goethite, and 90% pure goethite was obtained at 37 °C and pH 3.5. The goethite phase was nano-sized and had relatively large specific surface area (133 m²·g⁻¹), leading to high sorption capacity for metal oxyanions. Schwertmannite was also a good adsorbent for oxyanions, regardless of the smaller specific surface area. Our results indicate that these acidophilic microbial cultures serve as a simple rapid system for the synthesis of nanostructured goethite as well as schwertmannite. Full article