Search Results (2)

In recent years, perovskite solar cells (PSCs), often referred to as the third generation, have rapidly proliferated. Their most prominent deficiencies are their low efficiency and poor stability. To enhance their productivity, a combination of silicon and perovskite is employed. Here, we present a 3D simulation analysis of various electrical and optical properties of PSCs using the SILVACO simulation software. Using the inverted planar method with inorganic transport materials and the proper selection of anti-reflective coatings with a back contact layer increases the efficiency of PSCs to 28.064%, and enhances their stability without using silicone composites. Several materials, including CaF₂, SiO₂, and Al₂O₃, with various thicknesses have been employed to investigate the effect of anti-reflective coatings, and to improve the efficiency of the simulated PSC. The best thickness of the absorbent layer is 500 nm, using a CaF₂ anti-reflective coating with an optimal thickness of 110 nm. A polymer composition of Spiro-OMeTAD and inorganic materials Cu₂O and NiOx was used as the hole transport material (HTM) and inorganic ZnO was employed as the electron transport material (ETM) to optimize the solar cell efficiency, and an optimized thickness was considered for these materials. Yields of 29.261, 28.064 and 27.325% were obtained for Spiro-OMeTAD/ZnO, Cu₂O/ZnO and NiOx/ZnO, respectively. Thus, Spiro-OMeTAD yields the highest efficiency. This material is highly expensive with a complex synthesis and high degradability. We proposed to employ Cu₂O to alleviate these problems; however, this reduces the efficiency by 1.197%. As a graphene connector has high flexibility, reduces cell weight, and is cheaper and more accessible compared to other metals, it was regarded as an optimal alternative. The simulation results indicate that using the inverted planar method with inorganic transport materials for graphene-based PSCs is highly promising. Full article

The use of a fiber optic quasi-distributed sensing technique for detecting the location and severity of water leakage is suggested. A novel fiber optic sensor probe is devised with a vessel of water absorption material called as water combination soil (WCS) located between two highly reflected connectors: one is a reference connector and the other is a sensing connector. In this study, the sensing output is calculated from the reflected light signals of the two connectors. The first reflected light signal is a reference and the second is a sensing signal which is attenuated by the optical fiber bending loss due to the WCS expansion absorbing water. Also, the bending loss of each sensor probe is determined by referring to the total number of sensor probes and the total power budget of an entire system. We have investigated several probe characteristics to show the design feasibility of the novel fiber sensor probe. The effects of vessel sizes of the probes on the water detection sensitivity are studied. The largest vessel probe provides the highest sensitivity of 0.267 dB/mL, while the smallest shows relatively low sensitivity of 0.067 dB/mL, and unstable response. The sensor probe with a high output value provides a high sensitivity with various detection levels while the number of total installable sensor probes decreases. Full article