Search Results (2)

Introduction: Intra-abdominal pressure (IAP) monitoring is crucial for the detection and prevention of intra-abdominal hypertension (IAH) and abdominal compartment syndrome (ACS). In the 1970s, air-filled catheters (AFCs) for urodynamic studies were introduced as a solution to overcome the limitations of water-perfused catheters. Recent studies have shown that for correct IAP measurement with traditional AFC, the bladder needs to be primed with 25 mL of saline solution to allow pressure wave transmission to the transducer outside of the body, which limits continuous IAP monitoring. Methods: In this study, a novel triple balloon, air-filled TraumaGuard (TG) catheter system from Sentinel Medical Technologies (Jacksonville, FL, USA) with a unique balloon-in-balloon design was evaluated in a porcine and cadaver model of IAH via laparoscopy (IAP_gold). Results: In total, 27 and 86 paired IAP measurements were performed in two pigs and one human cadaver, respectively. The mean IAP_TG was 20.7 ± 10.7 mmHg compared to IAP_gold of 20.3 ± 10.3 mmHg in the porcine study. In the cadaver investigation, the mean IAP_TG was 15.6 ± 10.8 mmHg compared to IAP_gold of 14.4 ± 10.4 mmHg. The correlation, concordance, bias, precision, limits of agreement, and percentage error were all in accordance with the WSACS (Abdominal Compartment Society) recommendations and guidelines for research. Conclusions: These findings support the use of the TG catheter for continuous IAP monitoring, providing early detection of elevated IAP, thus enabling the potential for prevention of IAH and ACS. Confirmation studies with the TraumaGuard system in critically ill patients are warranted to further validate these findings. Full article

As the techniques to connect percutaneous coronary intervention (PCI) balloons and the inflation syringe vary in the instructions for use and in practice, we measured the amount of air in PCI balloons after testing three connection methods to an inflation syringe. Following the preparation using one of the three methods, 114 balloons and stent balloons were tested four times. Method 1 connected the syringe and the balloon catheter directly after purging and filling the lumen, while method 3 omitted the purging and filling process. With method 2, the catheter lumen was purged, filled and fully vented via a three-way valve. The primary endpoint answered whether air remained in the balloon, and if so, the secondary endpoint indicated the total volume of remaining air. The connection with a three-way valve achieved significantly less air in the inflated balloon as compared with either direct connection approach (27% vs. 44% and 51%; p = 0.015). For the direct connection, no significant difference between purging and filling the lumen prior to making the connection or not existed. According to these findings, the best method to connect a PCI balloon to the inflation syringe while removing air involves using a three-way valve. Full article