Next Article in Journal
Effect of Interlaminar Toughness on the Residual Compressive Capacity of Carbon Fiber Laminates with Different Types of Delamination
Previous Article in Journal
Synthesis, Characterization and In Vitro Evaluation of Chitosan Nanoparticles Physically Admixed with Lactose Microspheres for Pulmonary Delivery of Montelukast
 
 
Article
Peer-Review Record

Effect of Pressure Difference between Inner and Outer Gas Layer on Micro-Tube Deformation during Gas-Assisted Extrusion

Polymers 2022, 14(17), 3559; https://doi.org/10.3390/polym14173559
by Bin Liu, Xingyuan Huang *, Shaoyi Ren and Cheng Luo
Reviewer 1:
Reviewer 2:
Polymers 2022, 14(17), 3559; https://doi.org/10.3390/polym14173559
Submission received: 14 July 2022 / Revised: 23 August 2022 / Accepted: 26 August 2022 / Published: 29 August 2022
(This article belongs to the Section Polymer Processing and Engineering)

Round 1

Reviewer 1 Report

The manuscript "Effect of pressure difference between inner and outer gas layer on micro-tube deformation during gas-assisted extrusion" is very interesting, new and original. My recommendation is "accept as is".

Author Response

Dear Reviewers:

  We appreciate you very much for your positive and constructive comments and suggestions on our manuscript entitled “Effect of pressure difference between inner and outer gas layer on micro-tube deformation during gas-assisted extrusion” (Manuscript ID: polymers-1840108).

    Thanks again to the hard work of the editor and reviewer!

Reviewer 2 Report

1. The conclusions should be given with data instead of using general statement only. 

2. It is noted that experimental were carried out in parallel to the modelling. Explicit model validation should be carried out to make the models trustworthy.

3. Some grammatical corrections are needed. For example, after each equation "where" instead of "Where" should be used when explaining the variables.

Author Response

Dear Reviewers:

   We appreciate you very much for your positive and constructive comments and suggestions .Please see the attachment about the response.

Author Response File: Author Response.doc

Back to TopTop