Search Results (3)

Performance analysis of the adsorptive separation of ethylene downstream of an oxidative coupling of methane (OCM) process, being an alternative process for converting methane content of natural gas or other methane-rich sources to ethylene, was studied in this research for a production capacity of 1 Mt/yr. This was motivated by observing promising adsorption characteristics and efficiency in the selective adsorption of ethylene using 13X zeolite-based sorbent. The energy and economic performance of alternative scenarios for retrofitting the adsorption unit into an integrated OCM process were analyzed. Simulations of the integrated OCM process scenarios include OCM unit, CO₂-hydrogenation, ethane dehydrogenation and methane reforming sections. The use of efficient ethylene adsorption separation enabled the improvement of the economic and energy efficiency of the integrated OCM process under specific operating conditions. For instance, the invested amount of energy and the associated energy cost per ton of ethylene in the cryogenic ethylene-purification section of the integrated process using adsorption unit are, respectively, 75% and 89% lower than the reference integrated OCM process. Under the conditions considered in this analysis, the return on investment for the final proposed integrated OCM process structure using adsorption separation was found to be less than 9 years, and the potential for further improvement was also discussed. Full article

Liquid-liquid extraction (LLE) is an established unit operation in the manufacturing process of many products. However, development and integration of multistage LLE for new products and separation routes is often hindered and is probably more cost intensive due to a lack of robust development strategies and reliable process models. Even today, extraction columns are designed based on pilot plant experiments. For dimensioning, knowledge of phase equilibrium, hydrodynamics and mass transport kinetics are necessary. Usually, those must be determined experimentally for scale-up, at least in scales of DN50-150 (nominal diameter). This experiment-based methodology is time consuming and it requires large amounts of feedstock, especially in the early phase of the project. In this study the development for the integration of LLE in a new manufacturing process for artemisinin as an anti-malaria drug is presented. For this, a combination of miniaturized laboratory and mini-plant experiments supported by mathematical modelling is used. System data on extraction and washing distributions were determined by means of shaking tests and implemented as a multi-stage extraction in a process model. After the determination of model parameters for mass transfer and plant hydrodynamics in a droplet measurement apparatus, a distributed plug-flow model is used for scale-up studies. Operating points are validated in a mini-plant system. The mini-plant runs are executed in a Kühni-column (DN26) for extraction and a packed extraction column (DN26) for the separation of side components with a throughput of up to 3.6 L/h, yield of up to 100%, and purity of 41% in the feed mixture to 91% after washing. Full article

In this study, an engineering tool for the design and optimization of pervaporation processes is developed based on physico-chemical modelling coupled with laboratory/mini-plant experiments. The model incorporates the solution-diffusion-mechanism, polarization effects (concentration and temperature), axial dispersion, pressure drop and the temperature drop in the feed channel due to vaporization of the permeating components. The permeance, being the key model parameter, was determined via dehydration experiments on a mini-plant scale for the binary mixtures ethanol/water and ethyl acetate/water. A second set of experimental data was utilized for the validation of the model for two chemical systems. The industrially relevant ternary mixture, ethanol/ethyl acetate/water, was investigated close to its azeotropic point and compared to a simulation conducted with the determined binary permeance data. Experimental and simulation data proved to agree very well for the investigated process conditions. In order to test the scalability of the developed engineering tool, large-scale data from an industrial pervaporation plant used for the dehydration of ethanol was compared to a process simulation conducted with the validated physico-chemical model. Since the membranes employed in both mini-plant and industrial scale were of the same type, the permeance data could be transferred. The comparison of the measured and simulated data proved the scalability of the derived model. Full article