Search Results (3)

The accurate modeling of complex freeze–thaw processes and hydrothermal dynamics within the active layer is challenging. Due to the uncertainty in hydrothermal simulation, it is necessary to thoroughly investigate the parameterization schemes in land surface models. The Noah-MP was utilized in this study to conduct 23,040 ensemble experiments based on 11 physical processes, which were aimed at improving the understanding of parameterization schemes and reducing model uncertainty. Next, the impacts of uncertainty of physical processes on land surface modeling were evaluated via Natural Selection and Tukey’s test. Finally, Technique for Order of Preference by Similarity to Ideal Solution (TOPSIS) was used to identify the optimal combination of parameterization schemes for improving hydrothermal simulation. The results of Tukey’s test agreed well with those of Natural Selection for most soil layers. More importantly, Tukey’s test identified more parameterization schemes with consistent model performance for both soil temperature and moisture. Results from TOPSIS showed that the determination of optimal schemes was consistent for the simulation of soil temperature and moisture in each physical process except for frozen soil permeability (INF). Further analysis showed that scheme 2 of INF yielded better simulation results than scheme 1. The improvement of the optimal scheme combination during the frozen period was more significant than that during the thawed period. Full article

In this paper, the enhanced nonlinear magnetic model of the low voltage interior permanent magnet synchronous machine (IPMSM) is developed using the frozen permeability (FP) technique in finite element analysis (FEA) FEMM 4.2 software. The magnetic model is derived by obtaining flux saturation maps for a wide range of dq stator currents. Furthermore, the FEA FP technique accounts for the corresponding offset in the flux maps due to the excitation of the permanent magnets, and well as for fitting the coefficients for the curve-fitting procedure. In order to demonstrate the usefulness of the proposed magnetic model, a nonlinear control strategy based on the maximum torque per ampere (MTPA) optimal algorithm for IPMSM is employed. The magnetic model and the MTPA control strategy are validated through a variety of computer simulations based on FEMM 4.2 and MATLAB R2023a software, as well as on a real IPMSM electric vehicle (EV) traction drive experimental setup. Full article

Loess landslides induced by the freeze–thaw effect frequently occur in Yili, China. Freeze–thaw cycles cause indelible changes in the soil microstructure, affecting its permeability. This study investigated the impacts of freeze–thaw cycles on the permeability of Yili loess using permeability tests on undisturbed (virgin, in situ) and remolded loess samples taken before and after freeze–thaw cycles. Scanning electron microscopy and nuclear magnetic resonance techniques were utilized to investigate the microscopic mechanism of the freeze–thaw process on the loess. Grey relation analysis (GRA) was employed to analyze the correlation between macroscopic permeability and microscopic parameters (maxi. radius, eccentricity, fractal dimension, directional probability entropy, and porosity). The results revealed that the permeability and all the microstructure parameters have roughly shown the same trend: “fluctuation–towards equilibrium–stability”. Firstly, the permeability coefficients of original and remolded loess experienced three and two peaked–trends, respectively, before 30 freeze–thaw cycles. The trends eventually stabilized within 30–60 freeze–thaw cycles. Increased number of freeze–thaw cycles disintegrated large particles in undisturbed loess into medium–sized particles, and particle shapes became more uncomplicated. Medium–sized particles in the remolded loess agglomerated to larger particles with more complex shapes. Furthermore, the overall porosity of the originally undisturbed loess decreased, and large and medium–sized pores transformed into small pores and micropores. In contrast, the overall porosity of remolded loess increased. Finally, the results revealed that permeability coefficients of the undisturbed and remolded loess became closely related with eccentricity and porosity, respectively. This study provides a reference for preventing and governing the loess landslides induced by the freeze–thaw cycles and permeability reduction in construction on loess in seasonally frozen areas in Yili. Full article