Search Results (2)

With the rapid development of industrial automation and power electronics, the requirements for electrical contact materials are increasing. However, traditional electrical contact materials encountered significant bottlenecks in terms of performance enhancement and production environmental friendliness. Therefore, this paper proposes a new material design idea that utilizes π-π interactions between graphene and compounds with conjugated structures in order to achieve uniform dispersion of graphene in the metal matrix and thus enhance the performance of composites. Based on this design idea, we used nicotinic acid, which has a conjugated structure and is safe, as the complexing agent, and successfully prepared high-quality silver-graphene (Ag-G) composite coatings with graphene uniformly dispersed in the metal matrix on copper substrates by composite electrodeposition technique. Subsequently, the mechanical properties of composite coatings were investigated by hardness test and X-ray diffractometer, and the tribological properties of the composite coatings and the comprehensive performance under the current carrying conditions were systematically evaluated by using friction and wear tester and load key life tester. The results show that the Ag-G composite coatings have significant advantages in mechanical, tribological, and current carrying conditions. This result not only verifies the feasibility of the design idea of the material, but also provides a new direction for the research and development of electrical contact materials. Full article

Herein we demonstrate a novel plating bath, free from cyanide, to plate a highly adherent nanocrystalline copper-silver (ncCuAg) coating on a stainless-steel substrate and its application as an antimicrobial coating. The microstructures, such as the grain size, texture, microstrain, and the crystalline preferential orientation of CuAg deposits, are systematically investigated by X-ray diffraction analysis. The range of 13.4–16.6 nm was discovered to be the crystallite size determined from the X-ray peak broadening (Scherrer’s formula). Both HRTEM, FESEM-EDS, XPS, and mapping analysis revealed that the ncCuAg coatings are composed of both Ag and Cu atoms. Electrochemical processes occurring during CuAg co-deposition were investigated by using linear sweep voltammetry (LSV), cyclic voltammetry (CV), and anodic linear stripping voltammetry (ALSV). Additionally, the coatings made of ncCuAg produced by these baths work well as antibacterial agents against gram-positive (Staphylococcus) and gram-negative bacteria (Escherichia coli). Full article