Search Results (2)

In austenitic steels, the tetragonal Z-phase (NbCrN) has frequently been credited with beneficial strengthening effects during dislocation creep. In the modified Z-phase, niobium is partially substituted by vanadium. The basic objective of this contribution is a detailed characterization of the modified Z-phase in vanadium bearing austenitic AISI 316LN+Nb+V and HR3C steels. Experimental activities were focused on crystallography, thermodynamic and dimensional stability, kinetics of precipitation (TTP diagram) and solvus temperature of the modified Z-phase in the steels examined. Thermodynamic modelling was used for prediction of stable minor phases and solvus temperature of the modified Z-phase. Kinetics of precipitation of the (Nb,V)CrN phase in the AISI 316LN+Nb+V steel was experimentally investigated in the temperature interval of 550–1250 °C. The kinetics of precipitation of the modified Z-phase in austenitic matrix was fast. Results of diffraction studies on particles of the modified Z-phase confirmed the existence of the tetragonal unit cell already after short-term annealing. The solvus temperature of the modified Z-phase in austenitic steels was determined to be lower than that for the NbCrN phase. The decrease in the solvus temperature is dependent on the vanadium content in austenitic steels. Both thermodynamic calculations and experimental results proved that the thermodynamical stability of the modified Z-phase in austenite was high. More data are needed for evaluation of long-term dimensional stability of the (Nb,V)CrN phase in austenitic steels at temperatures for their engineering applications. Full article

Time-temperature-precipitation (TTP) diagrams deliver important material data, such as temperature and time ranges critical for precipitation during the quenching step of the age hardening procedure. Although the quenching step is continuous, isothermal TTP diagrams are often applied. Together with a so-called Quench Factor Analysis, they can be used to describe very different cooling paths. Typically, these diagrams are constructed based on mechanical properties or microstructures after an interrupted quenching, i.e., ex situ analyses. In recent years, an in situ calorimetric method to record continuous cooling precipitation diagrams of aluminum alloys has been developed to the application level by our group. This method has now been transferred to isothermal experiments, in which the whole heat treatment cycle was performed in a differential scanning calorimeter. The Al-Mg-Si-wrought alloy 6005A was investigated. Solution annealing at 540 °C and overcritical quenching to several temperatures between 450 °C and 250 °C were followed by isothermal soaking. Based on the heat flow curves during isothermal soaking, TTP diagrams were determined. An appropriate evaluation method has been developed. It was found that three different precipitation reactions in characteristic temperature intervals exist. Some of the low temperature reactions are not accessible in continuous cooling experiments and require isothermal studies. Full article