Search Results (1)

Water pollution caused by emerging contaminants is increasing due to rising urbanization, industrialization, and agriculture production; therefore, new materials with high efficiency for wastewater decontamination are needed. A perovskite material based on 1% Ag-doped LaMnO₃ synthesized through a sol–gel technique was combined with PVP in a 1:10 (w/w) ratio and subjected to different temperature and microwave conditions at various time intervals. The composite materials were obtained as thin films (S1, S2) or powders (S3) and were analyzed by modern techniques. The SEM analysis showed strongly agglomerated, asymmetric formations for the S1, S2 materials; as for the S3 composite, irregularly shaped grains of perovskite were deposited on the polymer surface. Small, round formations across the surface, mainly organized as clusters with conic/square-shaped particles and observed asperity on top, were highlighted by AFM images. The XRD spectra confirmed the presence of both the perovskite and PVP phases, and the crystallite size of the materials was determined to be in the range of 33–43 nm. The structural analyses, FT-IR, and Raman spectroscopy proved the interactions between the perovskite and the polymer, which led to novel composite materials. The different methods used for the synthesis of the new materials influenced their features and behavior. Moreover, the composites were successfully tested for methyl orange (MO) elimination from an acidic aqueous solution in dark conditions, with fast and complete (>95%) MO degradation at pH = 2. Full article