Search Results (4)

Foam drainage agents enhance gas production by removing wellbore liquids. However, due to the ultra-high salinity environments of the Hechuan gas field (salinity up to 32.5 × 10⁴ mg/L), no foam drainage agent is suitable for this gas field. To address this challenge, we developed a novel nanocomposite foam drainage system composed of quaternary ammonium and two types of nanoparticles. This work describes the design and synthesis of a quaternary ammonium foam drainage agent and nano-engineered stabilizers. Nonylphenol polyoxyethylene ether sulfosuccinate quaternary ammonium foam drainage agent was synthesized using maleic anhydride, sodium chloroacetate, N,N-dimethylpropylenediamine, etc., as precursors. We employed the Stöber method to create hydrophobic silica nanoparticles. Carbon quantum dots were then prepared and functionalized with dodecylamine. Finally, carbon quantum dots were incorporated into the mesopores of silica nanoparticles to enhance stability. Through optimization, the best performance was achieved with a (quaternary ammonium foam drainage agents)–(carbon quantum dots/silica nanoparticles) ratio of 5:1 and a total dosage of 1.1%. Under harsh conditions (salinity 35 × 10⁴ mg/L, condensate oil 250 cm³/m³, temperature 80 °C), the system exhibited excellent stability with an initial foam height of 160 mm, remaining at 110 mm after 5 min. Additionally, it displayed good liquid-carrying capacity (160 mL), low surface tension (27.91 mN/m), and a long half-life (659 s). These results suggest the effectiveness of nanoparticle-enhanced foam drainage systems in overcoming high-salinity challenges. Previous foam drainage agents typically exhibited a salinity resistance of no more than 25 × 10⁴ mg/L. In contrast, this innovative system demonstrates a superior salinity tolerance of up to 35 × 10⁴ mg/L, addressing a significant gap in available agents for high-salinity gas fields. This paves the way for future development of advanced foam systems for gas well applications with high salinity. Full article

The Middle Permian Maokou Formation in the Sichuan Basin has huge resources and is an important target for natural gas exploration. In recent years, significant exploration breakthroughs have been made in the dolomite field of member Mao-2 in central Sichuan, and the gas production of several wells has exceeded 1 × 10⁶ m³/d, indicating promising prospects for exploration. However, the origin of the dolomite reservoir in member Mao-2 remains ambiguous, which restricts the accurate prediction of favorable reservoirs. This study focuses on drilling in the Hechuan area as its research object, by using a detailed description of the cores from member Mao-2 of seven wells; samples were selected for tests of the degree of dolomite cation ordering, stable carbon and oxygen isotopic compositions, strontium isotopic composition, rare earth elements, LA-ICP-MS element mapping and U-Pb dating. It is clarified that: (1) The crystalline dolomite of member Mao-2 in the Hechuan area is the main reservoir rock, and the heterogeneous vugs and fractures are the main reservoir space. The dolomite in member Mao-2 has been characterized by a low degree of cation ordering value (avg. 0.59), with values of δ¹³C (avg. 3.87‰), δ¹⁸O (avg. −7.15‰) and ⁸⁷Sr/⁸⁶Sr (avg. 0.707474) having similar geochemical characteristics to Middle Permian seawater; the REEs normalized distribution patterns have similar characteristics to limestone; and the U-Pb age (261.0~262.0 Ma) corresponds to the age in the Capitanian stage of the Permian Guadalupian Series. (2) Petrological studies show that member Mao-2 has vertical karstification zonation characteristics; syngenetic karstification controls the formation of a large-scale fracture-cave system in the phreatic zone; the dolomitization of sediment in the fracture-cave system occurred during the penecontemporaneous period with locally restricted seawater. (3) The main controlling factors of the reservoir were syngenetic karstification, early dolomitization and hydrothermal dissolution related to Emei taphrogenesis. The research results are of great significance for dolomite reservoir prediction; the highlands of paleogeomorphology with syndepositional faults are favorable areas for dolomite reservoirs. Full article

The Hechuan gas field is one of the tight gas reservoirs with the highest formation water salinity in China. The content of metal ions, such as calcium, magnesium, iron, and barium, is as high as 20 g/L. Severe scales in near-wellbore reservoir blocks the gas and liquid flow paths, affecting the normal production of gas wells. The analysis of scale samples shows that the scale compositions in the Hechuan gas field are complex, which are composed of calcium carbonate, calcium sulfate, barium sulfate, iron salt, silicate, and other inorganic scales. To dissolve these scales, 14 kinds of laboratory self-made chelating acids named AST-01 to AST-14, sequentially, were evaluated by the descaling rate, in which the chelating acid AST-01 was selected with a dissolution rate of 77.7%. Meanwhile, the optimal concentration and reaction time of AST-01 were investigated, and the concentrations of the corrosion inhibitor, the iron ion stabilizer, and surfactants were also optimized. Then, a chelating acid descaling formula was obtained, which was 15~20% of AST-01 chelating acid + 1.5~2.0% of corrosion inhibitor + 2.5% of iron ion stabilizer + 0.3% of drainage aid. A pilot field trial of this descaling formula was applied in a Hechuan X1 well. A remarkable result was obtained in that the shut-in tubing pressure recovery rate was increased by 14 times, the gas production was increased by 10 times, and the gas well resumed to produce continuously again. Full article

In order to reduce the cost of wellheads, the production rate of the gas wells in the Hechuan Gas Field are mostly measured in groups, which raises a stringent barrier for industries to determine the production rate of each single well. The technique for determining the production of a single well from the production of the well-group can be called the production splitting method (PSM). In this work, we proposed a novel PSM for the multi-well-monitor system (MWMS) on the basis of the Beggs and Brill (BB) correlation. This proposed method can account for the multi-phase flow together with the features of the pipelines. Specifically, we discretize the pipeline into small segments and recognize the flow pattern in each segment. The pressure drop along the pipeline is calculated with the Beggs and Brill correlation, and the production of each well is subsequently determined with a trial method. We also applied this proposed method to a field case, and the calculated results show that the results from this work undergo an excellent agreement with the field data. Full article