Sign in to use this feature.

Years

Between: -

Subjects

remove_circle_outline
remove_circle_outline
remove_circle_outline
remove_circle_outline
remove_circle_outline

Journals

remove_circle_outline

Article Types

Countries / Regions

remove_circle_outline

Search Results (1)

Search Parameters:
Keywords = DME (dimethly ether)

Order results
Result details
Results per page
Select all
Export citation of selected articles as:
11 pages, 3875 KiB  
Article
Study on the Common Rail Type Injector Nozzle Design Based on the Nozzle Flow Model
by Sang-Wook Han, Yun-Sub Shin, Hyun-Chul Kim and Gee-Soo Lee
Appl. Sci. 2020, 10(2), 549; https://doi.org/10.3390/app10020549 - 11 Jan 2020
Cited by 11 | Viewed by 4771
Abstract
In this paper, a nozzle flow model was used to design an injector nozzle and obtain initial spray conditions for the dimethyl ether (DME) common rail-injection system. In order to deliver the same amount of energy as that provided by diesel at a [...] Read more.
In this paper, a nozzle flow model was used to design an injector nozzle and obtain initial spray conditions for the dimethyl ether (DME) common rail-injection system. In order to deliver the same amount of energy as that provided by diesel at a low injection pressure of 50 MPa, the injector for DME needs nozzle holes with larger diameters and a higher SAC volume for the same injection duration. In addition, the needle lift and needle seat diameter should be increased to maintain a minimum flow area ratio. Although the vapour pressure and maximum injection pressure of DME are lower than those of diesel, the nozzle in a DME system showed higher discharge coefficients and effective nozzle exit diameters for the same injection duration owing to low kinematic viscosity. However, because the maximum injection pressure in DME is lower than that with diesel, and the length of the cavitation region is narrower. Full article
(This article belongs to the Section Mechanical Engineering)
Show Figures

Figure 1

Back to TopTop