Microstructure, Fatigue and Corrosion Behavior of Additively Manufactured Alloys
A special issue of Metals (ISSN 2075-4701). This special issue belongs to the section "Additive Manufacturing".
Deadline for manuscript submissions: closed (31 December 2022) | Viewed by 4047
Special Issue Editor
Interests: powder-based additive manufacturing; wire-based additive manufacturing; manufacturing multi-material components; microstructure; fatigue; corrosion behavior
Special Issues, Collections and Topics in MDPI journals
Special Issue Information
Dear Colleagues,
This Special Issue aims to review the state of the art in metal additive manufacturing. Manuscripts will focus on the latest developments and most recent data on processes based on the melting of powder and wire feedstocks as well as the structure and properties of additively manufactured alloys. Consequently, the collection of works will provide an overview of the most recent results related to the study of process–parameter–structure and process–parameter–property relationships. Advanced techniques for 3D printing process control will also be reviewed and the latest simulation models of different additive manufacturing processes will be covered.
Topics of interest include the latest advances in the electron-beam additive technology, including but not limited to the following:
- Powder-based additive manufacturing
- Wire-based additive manufacturing
- Printing parameter selection
- Product geometry control
- Product structure and properties control
- Fatigue behavior of additively manufactured alloys
- Corrosion behavior of additively manufactured alloys
- Additive manufacturing multi-material components
- Simulation of metal additive manufacturing
- Automation, control, and management of electron-beam systems
Prof. Dr. Evgeny A. Kolubaev
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Metals is an international peer-reviewed open access monthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- powder-based additive manufacturing
- wire-based additive manufacturing
- manufacturing multi-material components
- microstructure
- fatigue
- corrosion behavior