3D Printing of Hardmetals
A special issue of Metals (ISSN 2075-4701).
Deadline for manuscript submissions: closed (25 March 2022) | Viewed by 602
Special Issue Editor
Interests: hardmetals; cemented carbides; cermets; thermal analysis; gas analysis
Special Issues, Collections and Topics in MDPI journals
Special Issue Information
Dear Colleagues,
Tools made from hardmetals, cemented carbides, and/or cermets are essential for the industrial fabrication of many products in life science, automotive, oil and gas, and other areas of manufacturing. With increasing changes in production and the need to machine and shape new materials, new challenges for tool materials are also arising. To address many of them, additive manufacturing or 3D printing of hardmetals and cermets will be a solution to shorten the developing time for new tools, for on-site production, and to allow new geometrical freedom to increase performance in cutting, drilling, shaping, and all the other applications where hardmetals and cermets are used. However, hardmetals and cermets are quite unique in their microstructure and composition and work done in their additive manufacturing in the past has often resulted in insufficient material properties, which are not good enough for most applications. Thus, new and advanced additive manufacturing approaches and techniques are sought after in the industry.
Dr. Johannes Pötschke
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Metals is an international peer-reviewed open access monthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- 3D printing
- additive manufacturing
- hardmetals
- cermets
- cemented carbides
