Chemical and Physical Properties in Food Processing

Reversed-flow gas chromatography (R.F.G.C.) was employed to assess the impact of genetic modification on Saccharomyces cerevisiae yeast strains during the process of alcoholic fermentation, utilizing fig syrup. Multiple fermentations were carried out at various temperatures to evaluate the influence of genetic modifications on yeast strain efficiency. The study involved a wild-type yeast strain, W303, as a control and two genetically modified strains, W_M4_533 and W_M4_558, sharing the same genetic background as the wild type. Notably, the genetic modifications in the Msn4p transcription factor involved the substitution of serine residues with alanine at positions 533 and 558, resulting in the development of psychrophilic or ethanol-resistant strains. Utilizing the R.F.G.C. method enabled the differentiation of the duration of alcoholic fermentation phases, providing insights correlated to the yeast cell life cycle. The values of rate constants (k) for each phase, conducted with both wild-type and genetically modified cells using RFGC, aligned with the existing literature. Additionally, the calculation of activation energies for distinct phases revealed lower values for genetically modified strains compared to wild-type strains. This decrease in activation energies suggests enhanced efficiency in the alcoholic fermentation process for the genetically modified strains. Full article

Cold-pressed hemp oils are characterized by an intense color, which is undesirable when used directly. Therefore, research was undertaken on removing chlorophyll and carotenoids effectively. This publication presents the results of tests that verified the adsorption properties of seven bleaching earths (BE1–BE7) in two doses (2.5% and 5.0%) in the low-temperature bleaching process of hemp oils. These oils were obtained by cold and hot pressing of the seeds of three varieties of hemp (Cannabis sativa L.): Finola, Earlina 8FC, and Secuieni Jubileu. The color change and the content of carotenoid and chlorophyll pigments in the bleached oils were verified using the colorimetric method (CIE-Lab). The BEs used had different abilities to reduce the content of natural dyes connected with oil decolorization. The conducted research allowed us to characterize the influence of BEs on the organoleptic properties of the tested oils. Hemp oil obtained from the Secuieni Jubileu CP and HP hemp variety should be bleached with unmodified magnesian bentonite at 2.5%. Unmodified attapulgite clay is not recommended for this variety, as it strongly adsorbs carotenoids from the oil. Full article

Pumpkins are often used as a fodder component and food due to their high nutritional value and share of bioactive components (e.g., carotenoids, polyunsaturated fatty acid (PUFAs)). Due to their high moisture content, they must be preserved; drying is still the most popular method. Our work aimed to assess the optimal drying temperature to keep the best possible nutritional value of the raw material. For this purpose, pumpkin was dried at 40 °C, 60 °C and 80 °C. Then, the proximate composition, carotenoid content, fatty acids, and antioxidant properties were determined. The results indicate that the carotenoids were relatively stable up to 60 °C and then decreased sharply. Furthermore, antioxidant activity was the highest at 40 °C and 60 °C. However, in the case of PUFA content, drying at 80 °C was the most effective, probably due to the shorter exposure time to the stimulus. Full article

The elderly population in developed countries has increased rapidly in recent years; the elderly may be at greater risk of protein deficiency due to dietary, socio-economic, dental, and physical restrictions. Therefore, to address the issue of protein deficiency in elderly people, the present study aimed to enhance the protein content of high-gluten flour noodles, an Asian staple food, by supplementing them with soybean protein isolate (SPI) powder. The effect of SPI addition (5–20%, w/w) on composition, quality, texture, physical and sensory properties, and glycemic index (GI) of high-gluten flour noodles was investigated. The noodles made only from high-gluten flour served as control. In comparison to control noodles, 20% SPI noodles showed a rise in protein and moisture content from 16.17% to 30.64% and 36.06 to 44.84%, respectively. The cooking yield and cooking loss increased with an increase in SPI concentration compared to control noodles. Color characteristics analysis revealed the decreasing trend in brightness and yellowness of SPI noodles with minimal L* and b* values at a 20% SPI concentration. The addition of SPI also resulted in a decrease in the hardness and tensile strength of the noodles. The sensory analysis showed that 5% SPI noodles were more similar to control noodles in terms of flavor, taste, and overall acceptability. Moreover, the addition of SPI to the noodles significantly decreased the GI of the noodles reaching the standard of low-GI food. The findings of the current study indicate that soy protein noodles, besides supplementing the desired nutrients, may also prevent the risk of diabetes in elderly people. Full article

Dry-cured tuna is a traditional product manufactured in the Mediterranean region of Spain, known as mojama. The traditional salting-drying elaboration process attributes new organoleptic characteristics to the final product, changing its flavor, color, and nutritional value. This study aimed to evaluate the changes in physicochemical, biochemical, and microbiological parameters taking place during the process. The physicochemical parameters were affected by the processing steps (salting, salt-washing, and drying), except for total acidity and pH. The water activity value and relative moisture percentage decreased to 0.86 and 33.03%, respectively. Moreover, the addition of salt and the drying step increased the water-holding capacity. The lipid oxidation values increased from raw tuna loins to the final product (1.37 vs. 5.56 mg malondialdehyde/kg). Moreover, the total volatile basic nitrogen values increased in the final product, fundamentally due to the concentration effect caused by the water loss, although may also be due to the degradation of proteins during processing. The microbiological analysis showed that the values obtained in the dry-cured tuna were below the limits established by the reference regulation for dry-cured fish products. Full article

Standard unit operations/equipment have not evolved for the traditional rice varieties of the Cauvery Deltaic region of Tamil Nadu. The fame of traditional rice is increasing nowadays owing to its health benefits. Non-standard unit operations may cause rice grains to crack during milling, accumulating more broken rice and yields in products of inferior quality. As a result, research into the physical properties of rice is crucial for the development of rice processing equipment that minimizes post-harvest losses during milling. Hence, an assessment was made to evaluate 30 traditional rice cultivars on their Physical (grain length, width, thickness, shape, and size), gravimetric (bulk, true, tapped density, porosity, Carr’s index, and Hausner ratio), and engineering characteristics (equivalent, arithmetic, square mean, and geometric mean diameter) using standard protocols, with the goal of reviving and preserving older varieties. The results from the analysis showed significant variations (p < 0.05) between all properties that were evaluated. According to length, a substantial amount of traditional rice varieties were long grain (76.7%), whereas (16.7%) belonged to the medium type and (3.3%) were short-grain types, respectively. There were variations among the three different categories of local rice grains when it comes to size, ranging from 3.26 to 4.69 mm for arithmetic mean diameter, 2.84 to 4.00 mm for geometric mean diameter, and 3.02 to 4.28 mm for square mean diameter, respectively. Sphericity, aspect ratio, and surface area measurements of the samples varied from 37.7% to 81.2%, 0.26 to 1.00, and 25.4 to 50.1 mm², respectively. Of the 30 varieties, 28 were under the high amylose category, and 2 belonged to the intermediate type. The Pearson correlation was established to study the interrelationships between the dimensions and engineering properties. Principal component analysis (PCA) reduced the dimensionality of 540 data into five principal components (PC), which explained 95.7% of the total variance. These findings suggest that it is possible to revive old landraces through careful selection and analysis of these properties. The superior characteristics of these traditional varieties can be further evaluated for breeding programs in order to improve the cultivation of these cherished rice landraces to enhance nutritional security. Full article

Partial substitution of flour with soy protein isolate in bread making increases the protein content and nutritional value of baked goods as it contains more lysine than wheat flour. However, changes in the bread recipe alter the pH and amino acid content of the baked good, and product assessment is required to determine whether the product is a non-time/temperature control for safety food. This study examines the effects of substituting high-gluten flour with 2–8% soy protein isolate on bread quality and on the shelf life of the bread using the microbiological challenge test. The results indicate that increased soy protein isolate substitution reduces the volume and specific volume of bread. Six percent soy protein isolate-fortified bread also had a poorer taste, and, therefore, the optimal substitution amount is 4%. Based on the yeast and mold growth during the storage period, the 4% soy protein isolate-fortified bread has a shelf life of four days, while the 2% soy protein isolate-fortified bread has a shelf life of five days. The microbiological challenge test results revealed that the substitution of flour with soy protein isolate is conducive to Staphylococcus aureus growth within the bread. To summarize, the optimal soy protein isolate substitution in bread is 4%, which offers a four-day shelf life at room temperature. Full article