Adhesives Inspired by Nature: When Bionics Boost Adhesive Innovation
A special issue of Biomimetics (ISSN 2313-7673). This special issue belongs to the section "Biomimetic Surfaces and Interfaces".
Deadline for manuscript submissions: 20 September 2024 | Viewed by 32
Special Issue Editor
Interests: tribology; bio-tribology; wear; friction; adhesion; biomimetics; mushroom-shaped microstructure; substrate; mechanical proprieties; surface roughness; surface texturing; tribology of biomaterials and biological tissues
Special Issue Information
Dear Colleagues,
Elements of nature, including plants, insects, and marine animals, exhibit distinct surface properties in their various components, including the leaves, wings, eyes, legs, and skin. These include water repellency, anti-adhesion, and anti-reflection. However, some natural surface properties serve as adhesive pads that allow insects and certain animals to adhere to and run on a variety of uneven surfaces in nature. These multifunctional surface properties are a result of complex three-dimensional and hierarchical surface structures with controlled surface chemistry and mechanical flexibility. In recent decades, there has been significant progress in understanding the fundamental aspects of surface and interfacial phenomena related to such adhesive multifunctional surfaces. This progress has also extended to the design, fabrication, and applications of adhesive surfaces and materials inspired by nature. The new Special Issue, entitled "Adhesives Inspired by Nature: When Bionics Boost Adhesive Innovation", in the open access journal Biomimetics will allow researchers in the field to publish their latest progress in nature-inspired adhesive surfaces, covering areas such as physics, chemistry, biology, material science, and various engineering disciplines
Dr. Haytam Kasem
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Biomimetics is an international peer-reviewed open access monthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2200 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- biomimetics
- adhesive mechanisms
- textured surfaces
- tribological performances
- bio-materials
