Next Article in Journal
Surface Engineering for Bone Implants: A Trend from Passive to Active Surfaces
Next Article in Special Issue
Abrasion, Erosion and Cavitation Erosion Wear Properties of Thermally Sprayed Alumina Based Coatings
Previous Article in Journal
Spreading Behavior and Morphology of Ethylene Methacrylic Acid (EMAA) Deposits via the Flame Spray Process
Previous Article in Special Issue
Microstructure and Properties of Plasma Sprayed Lead Zirconate Titanate (PZT) Ceramics
Article Menu
Issue 2 (June) cover image

Export Article

Coatings 2012, 2(2), 94-94; doi:10.3390/coatings2020094

Correction: Microstructure and Properties of Plasma Sprayed Lead Zirconate Titanate (PZT) Ceramics. Coatings 2012, 2, 64-75
Pavel Ctibor 1,*, Zdenek Pala 1, Hanna Boldyryeva 1, Josef Sedláček 2 and  Viliam Kmetík 1
Institute of Plasma Physics ASCR, Za Slovankou 3, 182 00, Praha 8, Czech Republic; Email:
Department of Electrotechnology, Faculty of Electrical Engineering, Czech Technical University, Technická 2, 166 27, Praha 6, Czech Republic; Email:
Author to whom correspondence should be addressed; Email: Tel.: +420-266053717; Fax: +420-286586389.
Received: 12 June 2012 / Accepted: 12 June 2012 / Published: 19 June 2012

The authors wish to make the following correction to this paper: the correct number of the project granted by the Czech Science Foundation is P108/12/1872.


The feedstock material was supported by the project TA01010878 grantedby the Technology agency of the Czech Republic. The analytic techniques were supported by the Czech Science Foundation under the project P108/12/1872. The authors thank J. Šimek and M. Munzar (SAM holding, Miletín, Czech Republic) for spraying the samples.


  1. Ctibor, P.; Pala, Z.; Boldyryeva, H.; Sedláček, J.; Kmetík, V. Microstructure and properties of Plasma Sprayed Lead Zirconate Titanate (PZT) ceramics. Coatings 2012, 2, 64–75. [Google Scholar] [CrossRef]
Coatings EISSN 2079-6412 Published by MDPI AG, Basel, Switzerland RSS E-Mail Table of Contents Alert
Back to Top