Next Article in Journal
Active and Reactive Power Adjustment of a Synchronous Generator Connected to Infinite Bus System by Fuzzy Logic Controller
Previous Article in Journal
Informativeness of Parallel Kalman Filters
Article Menu

Article Versions

Export Article

Open AccessArticle
Math. Comput. Appl. 1996, 1(1), 97-104; doi:10.3390/mca1010097

Computer Aided Constrained Optimisation of Cutting Conditions in Drilling Operations on a CNC Lathe by Using Geometric Programming

Gaziantep Üniversitesi Müh. Fak. Makina Müh. BöL, 27310 GAZİANTEP, Turkey
*
Author to whom correspondence should be addressed.
Published: 1 June 1996
Download PDF [3389 KB, uploaded 1 April 2016]

Abstract

This paper discusses the use of the geometric programming method to determine the optimum values of cutting speed and feed rate which yield minimum cost in a drilling operation that is performed on a CNC lathe, During the formulation of the problem a number of constraints are considered.
This is an open access article distributed under the Creative Commons Attribution License (CC BY 3.0).

Scifeed alert for new publications

Never miss any articles matching your research from any publisher
  • Get alerts for new papers matching your research
  • Find out the new papers from selected authors
  • Updated daily for 49'000+ journals and 6000+ publishers
  • Define your Scifeed now

SciFeed Share & Cite This Article

MDPI and ACS Style

Sönmez, A.İ.; Baykasoğlu, A.; Filiz, İ.H. Computer Aided Constrained Optimisation of Cutting Conditions in Drilling Operations on a CNC Lathe by Using Geometric Programming. Math. Comput. Appl. 1996, 1, 97-104.

Show more citation formats Show less citations formats

Article Metrics

Article Access Statistics

1

Comments

[Return to top]
Math. Comput. Appl. EISSN 2297-8747 Published by MDPI AG, Basel, Switzerland RSS E-Mail Table of Contents Alert
Back to Top