ISPRS Int. J. Geo-Inf. 2018, 7(2), 59; https://doi.org/10.3390/ijgi7020059
Introduction to the Special Issue: “Research and Development Progress in 3D Cadastral Systems”
Peter van Oosterom 1,*
and Efi Dimopoulou 2
and Efi Dimopoulou 21
Section GIS technology, Department OTB Faculty of Architecture and the Built Environment, Delft University of Technology, Julianalaan 134, 2628 BL Delft, The Netherlands
2
School of Rural and Surveying Engineering, National Technical University of Athens, Iroon Polytechneiou, 9, Athens 15780, Greece
*
Author to whom correspondence should be addressed.
Received: 5 February 2018 / Revised: 5 February 2018 / Accepted: 6 February 2018 / Published: 9 February 2018
(This article belongs to the Special Issue Research and Development Progress in 3D Cadastral Systems)
Note: In lieu of an abstract, this is an excerpt from the first page.
Excerpt
The content of this Special Issue has its origin in the “
Figure 1
This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (CC BY 4.0).
Share & Cite This Article
MDPI and ACS Style
van Oosterom, P.; Dimopoulou, E. Introduction to the Special Issue: “Research and Development Progress in 3D Cadastral Systems”. ISPRS Int. J. Geo-Inf. 2018, 7, 59.
Note that from the first issue of 2016, MDPI journals use article numbers instead of page numbers. See further details here.
Related Articles
Article Metrics
Comments
[Return to top]
ISPRS Int. J. Geo-Inf.
EISSN 2220-9964
Published by MDPI AG, Basel, Switzerland
RSS
E-Mail Table of Contents Alert