1. Brief Review of Modern Experiments in the Low-Threshold Field Emission
In numerous recent experiments, see for instance [
1,
2,
3,
4,
5,
6,
7,
8], extremely low-threshold field emission from the carbon nano-clusters was observed for electric fields
V/cm). This is a surprisingly strong effect, because the field initiating a noticeable emission from these materials is 2–3 orders less than the field required for the field-emission from the traditional metals and semiconductors. Despite the obviously unusual nature of the effect, numerous authors, see for instance [
6,
8], have attempted to explain the low-threshold phenomenon trivially with use of the classical Fowler-Nordheim machinery, based on the enhancing of the field at the micro-protrusions. They assume that the local field
near the emitting center is calculated as
, where
γ is the field enhancement coefficient, defined by the micro-geometry, and
is the field of the equivalent flat capacitor. This completely classical explanation of the low -threshold emission phenomenon is not universal, and certainly non valid for carbon-covered cathodes. This has been considered in our recent papers [
2,
3,
7] because the surface of the carbon flakes, obtained by the detonation synthesis are perfectly smooth with rare and relatively small protrusions. These protrusions are able to lower the threshold by a factor of 5, while a lowering factor of
is observed in our experiments. We suggested in [
2,
3,
7] an alternative explanation of the threshold lowering (field enhancement) based on the dimensional quantization in the under-surface space-charge region on the metal-graphene interface.
Recent experiments done by our group confirm the continuity of spectrum 2D-size quantization and allow us to estimate the effective mass and the de Broglie wavelength in space-charge region depending on electron’s concentration , where , A is the current and cm—the area of the cathode, s. Monitoring of current density allows us to estimate the experimental density of charges Coul/cm, which corresponds to density of electrons cm.
On another hand, from the size-quantization theory [
9] the 2D density of electrons is estimated as
Here
is the effective electron mass,
—the size-quantization level,
—the Fermi level. In our case
The de Broglie electron wavelength [
9] in graphene flakes is
Based on the preceding Equations (
2) and (
3), we estimate the electron effective mass and the de Broglie electron
At room temperature we have
nm,
. We should notice that the experiment based estimates yield the values
. The above value of the electron effective mass yield the values one order higher than ones for graphene, obtained from independent experiments, see [
10].
Another important result obtained by our group is discovery of the second maximum on the dependence of distribution of electron on total energy. This result does not have yet an adequate interpretation.
The classical Fowler-Nordheim machinery used to calculate the transmission coefficient for simple rectangular potential barrier, see [
11], gives an exponentially small value of the transmission coefficient
with
for the under - barrier tunneling with
, and the width of the barrier is equal to
a.
In our papers [
2,
7] we assume that the spectrum of the size quantization is discrete and reduced to several discrete levels. Based on this assumption, we developed a resonance version of the classical Fowler-Nordheim machinery, considering the complex levels as resonances. The role of field enhancing factor in our interpretation was played by the small effective mass of electron in the carbon structure. Indeed, the field is measured by the steepness of the slope of the potential. However, the effective steepness is calculated with respect to the de Broglie wavelength which is
times bigger than the conventional de Broglie wavelength at the same energy. The corresponding formula for the transmission coefficient was derived [
7] for the general 1D model of the space-charge region, with complex discrete spectrum of the surface levels.
2. The Resonance Interpretation
Presence of these resonance details in the barrier may result in much larger values of the transmission coefficient
T for electrons with certain energy. In [
2] we emulated
T by delta-barrier supplied with inner structure defined by a differential operator on a finite interval. We realize that this differential operator does not have any physical meaning itself, but serves just as a mathematical detail of the model. Besides, fitting of the corresponding model, with this differential operator, presents some technical difficulties, in particular solving the relevant inverse problem. In [
7] we base our conclusions upon a simpler model, substituting inner structure by a finite matrix, which is fit based on experimental data on size-quantization. Similarly to [
2] we emulate the barrier in [
7] by the generalized Datta and Das Sarma boundary condition, see [
7,
12,
13]. The 1D solvable model of the contact zone of the emitter is constructed hereafter based on division of the normal coordinate into three layers; the metal (1)
, the vacuum (2),
and carbon deposit (3),
., with the portions of the wave-function denoted correspondingly.
The components
of the wave-function of the electron satisfy on the domains the Schrödinger equations, for instance
Here
, end
is a rectangular barrier hight
q.
Following [
2,
7], we model the component
of the wave-function on the barrier—the solution of a differential equation on a finite interval, by the finite vector and, correspondingly, substitute the barrier by a zero-range model with an inner structure, see [
14], defined by the finite Hermitian matrix
A. The corresponding boundary form is represented in terms of the corresponding “boundary values”
as
The corresponding boundary forms of the inner structure in terms of the adequate boundary values is
The zero-range model of the resonance field emission is defined by the boundary condition imposed on the data, which annihilate the sum of the boundary forms
. When discussing the zero-range model of the interface lattice, we assume, that the deposit zone is substituted by the model barrier, but the zone inherits the small effective mass
from the deposit on the contact interface. In particular the sum is vanishing while the boundary data are imposed to the generalized Datta-Das Sarma boundary condition at the contact of the deposit and vacuum (that is exactly on the barrier). This boundary condition is defined, similarly to Datta-Das Sarma, [
12], by the vector parameter
as:
The quantum-mechanical meaning of the similar parameter
in the case of T-junction is revealed in [
12]. In our case, the parameter is defined by the geometry of the contact zone. We assume here that it can be fitted based on the experimental data. The boundary values
of the component of the wave-function on the barrier are connected via the corresponding Weyl-Titchmarsh function
, and selected “deficiency” subspace
N, defining the connection of the inner space (the space of the size-quantization on the barrier), with the vacuum and the deposit. The energy
E plays a role of the spectral parameter, so that the dimension of the operator
A is energy. Hereafter, we assume that the Weyl function
is scalar, but our model can be easily extended to the general case with multidimensional Weyl function. Assuming that the wave-function of the electron in the deposit and in vacuum is a scattered wave, we represent the components of it in the deposit and in vacuum as
. Substituting this scattering Ansatz into the above boundary conditions, we obtain an expression for the transmission coefficient
T from the deposit into vacuum :
In the non-resonance situation,
Const, the Datta-Das Sarma parameter
defines the exponential small transmission rate
. Then, in the resonance situation,
the transmission is exponentially small on the complement of the set of poles of
, but is essentially greater at the poles
,
, where
. With regard of
we have at the poles, that
which can be essentially greater than exponential estimate
. Then, in the resonance situation,
based on
we see the peak of the transmission coefficient at the eigenvalues of the matrix
A which play a role of the levels of the size - quantization on the barrier (with special boundary conditions on the contact of the barrier with the inner part of the deposit and the vacuum. This condition is compatible with unitarity of the full scattering matrix on the interface deposit-vacuum, if the weights
are taken into account.
In the ballistic regime, the current
j is proportional to the weighted integral of the transmission coefficient
T. In particular, for linear spectrum
the integration is performed on the energy variable
Here,
is the voltage drop,
is the Fermi distribution, and
is the Fermi velocity. For low temperature the integrand with the Fermi distribution is reduced to
In our case we have generally:
with
, and, for low temperature, just the value of
T at the Fermi level, with a trivial coefficient.
3. Discussion: The Role of the Interface Structure
The above model of resonance tunneling through the size - quantization level presents a qualitative interpretation the low-threshold emission. The magnitude of the threshold measured in experiment (see [
2,
3]) is
meV. These values of the threshold may be qualitatively explained based on resonance tunneling through the size-quantization level. Up to choice of the statistical distribution, this magnitude corresponds to
, for room temperature.
The reason for this may have various causes. First of all: the one-dimensional version of the electron transmission through the interface barrier (even with regard to size-quantization levels). Another cause is absence of theoretical equivalent of the multilayer structure in the accepted model of the cathode, usually substituted by the two-layer structure of the contact of graphene and the metal surface, without taking into account mutual influence of the components. Finally, the naive model does not take into account the two-dimensional structure of the graphene-metal interface, which may play an essential role for both classical Fowler-Nordheim or resonance transmission scenario of the field emission. In any case, the enhanced values of the measured electron mass may be interpreted as evidence of the emission from narrow spectral bands, rather than one from the discrete resonance levels. Even considering the simplest model of the graphene-metal interface, we discover that the electron mass may be greater than in pure graphene due to possible level crossings arising from the dispersion curves of the materials involved—the graphene and the metal. Even a naive model of the graphene-metal interface shows the levels crossings and relevant super-narrow spectral bands and gaps with various values of effective electron mass.
Indeed, let us observe the influence of periodicity of the graphene-metal interface in the simplest case
of 1D of the periodic structure of the interface. Using a discrete model of a 1D periodic graphene-metal superlattice, we obtain the dispersion function of the lattice, with relevant Weyl-Titchmarsh function
, taking into account an interaction only between the nearest neighbors in the lattice:
Here, the Weyl-Titchmarsh function of the graphene-metal superlattice is composed of the functions of component lattices and the interaction is taken into account by
matrix
B. The effective mass of electron in the resulting interface lattice does not coincide with the mass in each of component lattices, but depends on the interaction
β. Generally, it may be greater than the mass of electron in graphene. The Weyl-Titchmarsh function has a positive imaginary part in the upper half-plane of energy
and real on the spectral gaps of the lattice. Then the effective mass of the electron on the lattice is calculated as
, which yields, at the ends of the spectral bands, where
Based on effective mass we may judge on density of states which allows to estimate the emission current based on above formulae for the transmission coefficient Equation (
8). While calculating the transmission coefficient with regard of 1D periodic structure of the graphene-metal interface,
we notice that the transmission coefficient may be large on the gaps of the interface-lattice and relatively small on the open spectral bands of the interface. For the 2D interface, two spectral bands may overlap, yielding the resulting picture with two maxima in the electron’s distribution on full energy, see [
1]. We plan to continue our study on the corresponding phenomena in our upcoming publications, based on 2D mathematical tools prepared in our preceding papers, see for instance [
13].